Makita 3621 Instruction Manual

Also see for 3621: Instruction manual

Contents

10When cutting, move the tool with the straight guide flush withthe side of the workpiece. If the distance (A) between theside of the workpiece and the cutting position is too wide forthe straight guide, or if the side of the workpiece is notstraight, the straight guide cannot be used. In this case,firmly clamp a straight board to the workpiece and use it as aguide against the router base. Feed the tool in the directionof the arrow.Templet guide (optional accessory)The templet guide provides a sleeve through which the bitpasses, allowing use of the router with templet patterns.To install the templet guide, loosen the screws on the toolbase, insert the templet guide and then tighten the screws.Secure the templet to the workpiece. Place the tool on thetemplet and move the tool with the templet guide slidingalong the side of the templet.A0032610032621. Screw2. Base plate3. Templet guide1 230032631. Bit2. Templet guide3. Base4. Templet5. Workpiece1 2345003264