Makita 3710 Instruction Manual

Also see for 3710: Technical instructions Instruction manual Instruction manual Instruction manual Instruction manual

Contents

410. Be careful of the bit rotating direction and thefeed direction.11. Do not leave the tool running. Operate the toolonly when hand-held.12. Always switch off and wait for the bit to come toa complete stop before removing the tool fromworkpiece.13. Do not touch the bit immediately after operation;it may be extremely hot and could burn yourskin.14. Always lead the power supply cord away fromthe tool towards the rear.15. Do not smear the tool base carelessly with thin-ner, gasoline, oil or the like. They may causecracks in the tool base.16. Draw attention to the need to use cutters of thecorrect shank diameter and suitable for thespeed of the tool.17. Some material contains chemicals which may betoxic. Take caution to prevent working dust inha-lation and skin contact. Follow material suppliersafety data.SAVE THESE INSTRUCTIONSWARNING:MISUSE or failure to follow the safetyrules stated in this instruction manualmay cause serious personal injury.SYMBOLSUSD201-2The followings show the symbols used for tool.V............................voltsA ...........................amperesHz..........................hertz..................alternating current.......................no load speed.......................Class II Construction.../min ....................revolutions or reciprocation perminuteFUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function onthe tool.Adjusting bit protrusionTo adjust the bit protrusion, loosen the clamping nut andmove the tool base up or down as desired by turning theadjusting screw. After adjusting, tighten the clamping nutfirmly to secure the tool base.Adjusting angle of tool baseLoosen the wing bolts and adjust the angle of the toolbase (5° per graduation) to obtain the desired cuttingangle.Adjusting amount of chamferingTo adjust the amount of chamfering, loosen the wing nutsand adjust the trimmer shoe.CAUTION:• With the tool unplugged and switch in the “OFF”position, rotate the collet nut on the tool severaltimes to be sure that the bit turns freely and doesnot contact the base or trimmer shoe in any way.Switch actionTo start the tool, move the switch lever to the I (ON) posi-tion. To stop the tool, move the switch lever to the O(OFF) position.n˚1. Bit protrusion2. Base3. Clamping nut4. Scale5. Adjusting screw1. Wing bolt2. Graduation3. Wing nut4. Trimmer shoe5. Amount ofchamfering6. Base1. Switch lever123450066311234560066321006614