Makita 407 Instruction Manual

Contents

Makita 407 Instruction Manual Manual pdf 3 page image

3damaged should be carefully checked todetermine that it will operate properly andperform its intended function. Check foralignment of moving parts, binding of movingparts, breakage of parts, mounting, and anyother conditions that may affect its operation.A guard or other part that is damaged shouldbe properly repaired or replaced by anauthorized service center unless otherwiseindicated elsewhere in this instruction manual.Have defective switches replaced byauthorized service center. Don’t use thecleaner if switch does not turn it on and off.20. REPLACEMENT PARTS. When servicing, useonly identical replacement parts.21. STORE IDLE CLEANER. When not in use, thecleaner should be stored indoors.22. Be kind to your cleaner. Rough handling cancause breakage of even the most sturdily builtcleaner.23. Do not attempt to clean the exterior or interiorwith benzine, thinner or cleaning chemicals.Cracks and discoloration may be caused.24. Do not use cleaner in an enclosed spacewhere flammable, explosive or toxic vaporsare given off by oil-base paint, paint-thinner,gasoline, some mothproofing substances, etc.,or in areas where flammable dust is present.25. Do not leave the cleaner cord lying on the floorafter you have finished a cleaning job. It canbecome a tripping hazard or may causedamage to the cleaner.26. Do not operate this or any tool while under theinfluence of drugs or alcohol.27. As a basic rule of safety, use safety goggles orsafety glasses with side shields.28. Use a dust mask in dusty work conditions.29. The cleaner is not intended for use by youngchildren or infirm persons withoutsupervision.30. Young children should be supervised toensure that they do not play with the cleaner.31. Never handle plug cord or cleaner with wethands.32. Use extreme caution when cleaning on stairs.SAVE THESE INSTRUCTIONS.FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off beforeconnecting the tool to a power source.Switch action1008450To start the tool, press the ''ON'' side of the switch. Tostop, press the ''OFF'' side of the switch.ASSEMBLYCAUTION:• Always be sure that the tool is switched off andunplugged before carrying out any work on thetool.Installing hoseCAUTION:• Do not fold, tug nor step on the hose.• Never yank the cleaner to carry it.12008449Insert the hose into the hose inlet and turn clockwiseuntil fully secured.Installing polyethylene bag1234008453(Tool can be used without polyethylene bag also)Spread the polyethylene bag in the tank. Insert itbetween the holder plate and the tank, and pull it to thehose inlet. Hook up the other side of the bag on the pipe1. Polyethylenebag2. Hook3. Holder plate4. Tank1. Hose inlet2. Hose1. Switch