Makita 4326 Instruction Manual

Also see for 4326: Specifications Instruction manual Instruction manual Technical information Instruction manual

Contents

8(3) As the blade pierces the workpiece, slowlylower the base of the tool down onto theworkpiece surface.(4) Complete the cut in the normal manner.Finishing edges008094To trim edges or make dimensional adjustments, run theblade lightly along the cut edges.Metal cuttingAlways use a suitable coolant (cutting oil) when cuttingmetal. Failure to do so will cause significant blade wear.The underside of the workpiece can be greased insteadof using a coolant.Dust extraction1 2008095Clean cutting operations can be performed byconnecting this tool to a Makita vacuum cleaner. Insertthe hose of the vacuum cleaner into the hole at the rearof the tool. Lower the dust cover before operation.NOTE:• Dust extraction cannot be performed when makingbevel cuts.Rip fence (optional accessory)CAUTION:• Always be sure that the tool is switched off andunplugged before installing or removingaccessories.1. Straight cuts1Steel base type008096When repeatedly cutting widths of 160 mm or less,use of the rip fence will assure fast, clean, straightcuts.1Alminum base type008097To install, insert the rip fence into the rectangularhole on the side of the base with the fence guidefacing down. Slide the rip fence to the desiredcutting width position, then tighten the bolt tosecure it.1234Steel base type00277612 34Aluminum base type0054541. Bolt2. Fence guide3. Hex wrench4. Rip fence(Guide rule)1. Hex wrench2. Bolt3. Rip fence(Guide rule)4. Guide facing1. Rip fence(Guide rule)1. Rip fence(Guide rule)1. Dust cover2. Hose

/ 12

Related manuals for Makita 4326

Makita 4326 Instruction Manual

This manual is suitable for:

4326 4327 4328 4329

manualsdatabase

Your AI-powered manual search engine