Makita 4326 Instruction Manual

Also see for 4326: Specifications Instruction manual Instruction manual Instruction manual Technical information

Contents

8123008089Tilt the base until the desired bevel angle is obtained.The edge of the motor housing indicates the bevel angleby graduations. Then tighten the bolt to secure the base.12008090Front flush cuts123008091Loosen the bolt on the back of the base with the hexwrench and slide the base all the way back. Thentighten the bolt to secure the base.CutoutsCutouts can be made with either of two methods A or B.A) Boring a starting hole1008092For internal cutouts without a lead-in cut from anedge, pre-drill a starting hole 12 mm or more indiameter. Insert the blade into this hole to startyour cut.B) Plunge cutting008093You need not bore a starting hole or make a lead-in cut if you carefully do as follows.(1) Tilt the tool up on the front edge of the basewith the blade point positioned just above theworkpiece surface.(2) Apply pressure to the tool so that the frontedge of the base will not move when youswitch on the tool and gently lower the backend of the tool slowly.(3) As the blade pierces the workpiece, slowlylower the base of the tool down onto theworkpiece surface.(4) Complete the cut in the normal manner.Finishing edges008094To trim edges or make dimensional adjustments, run theblade lightly along the cut edges.Metal cuttingAlways use a suitable coolant (cutting oil) when cuttingmetal. Failure to do so will cause significant blade wear.The underside of the workpiece can be greased insteadof using a coolant.Dust extraction1 20080951. Dust cover2. Hose1. Starting hole1. Hex wrench2. Bolt3. Base1. Edge2. Graduation1. Hex wrench2. Bolt3. Base

/ 12

Related manuals for Makita 4326

Makita 4326 Instruction Manual

This manual is suitable for:

4326 4327 4328 4329

manualsdatabase

Your AI-powered manual search engine