Makita 5008MG Instruction Manual

Also see for 5008MG: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

700002929. Some material contains chemicals which maybe toxic. Take caution to prevent dustinhalation and skin contact. Follow materialsupplier safety data.30. Do not stop the blades by lateral pressure onthe saw blade.31. Always use blades recommended in thismanual. Do not use any abrasive wheels.32. Keep blade sharp and clean. Gum and woodpitch hardened on blades slows saw andincreases potential for kickback. Keep blade cleanby first removing it from tool, then cleaning it withgum and pitch remover, hot water or kerosene.Never use gasoline.33. Wear a dust mask and hearing protectionwhen use the tool.SAVE THESE INSTRUCTIONS.WARNING:DO NOT let comfort or familiarity with product(gained from repeated use) replace strict adherenceto safety rules for the subject product. MISUSE orfailure to follow the safety rules stated in thisinstruction manual may cause serious personalinjury.FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function onthe tool.Adjusting depth of cut2 1007326CAUTION:• After adjusting the depth of cut, always tighten thelever securely.Loosen the lever on the depth guide and move the baseup or down. At the desired depth of cut, secure the baseby tightening the lever.For cleaner, safer cuts, set cut depth so that no morethan one blade tooth projects below workpiece. Usingproper cut depth helps to reduce potential for dangerousKICKBACKS which can cause personal injury.Bevel cutting22.545502 31008186Positive stopperTurn the positive stopper so that the arrow on it pointsone of three positions (22.5°,45°,50°). Then, tilt the toolbase until it stops and secure the base with the lever. Atthis time, the same angle as the one that the arrowpoints is obtained.Setting bevel angleLoosen the lever and tentatively set the tool base at the0°bevel angle, then tighten the lever securely.Turn the positive stopper so that the arrow on it pointsone of three positions (22.5°,45°,50°) that is equal to orgreater than the desired bevel angle.Loosen the lever again and then tilt and secure the toolbase at the desired angle securely.1. Lever2. Positive stopper3. Arrow onpositive stopper1. Depth guide2. Lever

/ 12

Related manuals for Makita 5008MG

Makita 5008MG Instruction Manual

This manual is suitable for:

5008MG

manualsdatabase

Your AI-powered manual search engine