Makita 5201NA Instructional Manual

Also see for 5201NA: Instruction manual Parts Breakdown Technical information Instruction manual

Contents

12MAINTENANCE CAUTION:• Always be sure that the tool is switched off andunplugged before attempting to perform inspection ormaintenance.Replacing carbon brushesRemove and check the carbon brushes regularly. Replacewhen they wear down to the limit mark. Keep the carbonbrushes clean and free to slip in the holders. Both carbonbrushes should be replaced at the same time. Use only iden-tical carbon brushes.Use a screwdriver to remove the brush holder caps. Take outthe worn carbon brushes, insert the new ones and securethe brush holder caps.After replacing brushes, plug in the tool and break in brushesby running tool with no load for about 10 minutes. Thencheck the tool while running and electric brake operationwhen releasing the switch trigger. If electric brake is notworking well, ask your local Makita service center for repair.To maintain product SAFETY and RELIABILITY, repairs, anyother maintenance or adjustment should be performed byMakita Authorized or Factory Service Centers, always usingMakita replacement parts.ACCESSORIES CAUTION:• These accessories or attachments are recommended foruse with your Makita tool specified in this manual. Theuse of any other accessories or attachments mightpresent a risk of injury to persons. Only use accessoryor attachment for its stated purpose.If you need any assistance for more details regarding theseaccessories, ask your local Makita service center.• Steel & Carbide-tipped saw blades• Rip fence (Guide rule)• Wrench 22• Hex wrench 61. Limit mark10011451. Brush holder cap2. Screwdriver12001522Combination General purpose blade for fast and smooth rip,crosscuts and miters.Fine cross cuts For sand-free cuts cleanly against the grain.Crosscutting For smoother cross grain cuts. Slices cleanlyagainst grain.