Makita 6409 Instruction Manual

Also see for 6409: Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita 6409 Instruction Manual Manual pdf 2 page image

2ENGLISH (Original instructions)SPECIFICATIONSModel 6409/6409N 6410Steel 10 mm 10 mmCapacities Wood 25 mm 25 mmNo load speed (min -1) 2,200 0 - 2,200Overall length 248 mm 248 mmNet weight 1.2 kg 1.2 kgSafety class /II• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.• Specifications may differ from country to country.• Weight according to EPTA-Procedure 01/2003END201-5SymbolsThe following show the symbols used for the equipment.Be sure that you understand their meaning before use.읭 Read instruction manual.읭 DOUBLE INSULATION읭 Only for EU countriesDo not dispose of electric equipmenttogether with household waste material!In observance of European Directive2002/96/EC on waste electric andelectronic equipment and itsimplementation in accordance withnational law, electric equipment thathave reached the end of their life mustbe collected separately and returned toan environmentally compatiblerecycling facility. ENE032-1Intended useThe tool is intended for drilling in wood, metal andplastic. ENF002-1Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, andcan only be operated on single-phase AC supply. Theyare double-insulated in accordance with EuropeanStandard and can, therefore, also be used from socketswithout earth wire. ENG104-1For European countries onlyNoiseThe typical A-weighted noise level determined accordingto EN60745:Sound pressure level (LpA) : 79 dB(A)Uncertainty (K) : 3 dB(A)The noise level under working may exceed 80 dB (A).Wear ear protection.ENG202-3VibrationThe vibration total value (tri-axial vector sum)determined according to EN60745:Work mode: drilling into metalVibration emission (ah,D) : 2.5 m/s 2 or lessUncertainty (K) : 1.5 m/s 2ENG901-1• The declared vibration emission value has beenmeasured in accordance with the standard testmethod and may be used for comparing one toolwith another.• The declared vibration emission value may also beused in a preliminary assessment of exposure.WARNING:• The vibration emission during actual use of thepower tool can differ from the declared emissionvalue depending on the ways in which the tool isused.• Be sure to identify safety measures to protect theoperator that are based on an estimation ofexposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when itis running idle in addition to the trigger time).ENH101-12EC Declaration of ConformityWe Makita Corporation as the responsiblemanufacturer declare that the following Makitamachine(s):Designation of Machine: DrillModel No./ Type: 6409,6409N,6410are of series production andConforms to the following European Directives:98/37/EC until 28th December 2009 and then with2006/42/EC from 29th December 2009And are manufactured in accordance with the followingstandards or standardised documents:EN60745