Makita 6807 Instruction Manual

Also see for 6807: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

42. Always be sure you have a firm footing.Be sure no one is below when using the tool inhigh locations.3. Hold the tool firmly.4. Keep hands away from rotating parts.5. Do not touch the bit or the workpieceimmediately after operation; they may beextremely hot and could burn your skin.SAVE THESE INSTRUCTIONS.WARNING:DO NOT let comfort or familiarity with product(gained from repeated use) replace strict adherenceto safety rules for the subject product. MISUSE orfailure to follow the safety rules stated in thisinstruction manual may cause serious personalinjury.FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function onthe tool.Depth adjustment1 AB003557The depth can be adjusted by turning the locking sleeve.Turn it in "A" direction for less depth and in "B" directionfor more depth. One full turn of the locking sleeve equals1.5 mm change in depth.Adjust the locking sleeve so that the distance betweenthe tip of the locator and the screw head is approximately1 mm (3/64") as shown in the figure. Drive a trial screwinto your material or a piece of duplicate material. If thedepth is still not suitable for the screw, continue adjustinguntil you obtain the proper depth setting.12A00355812003559Switch action12003560CAUTION:• Before plugging in the tool, always check to seethat the switch trigger actuates properly and returnsto the "OFF" position when released.To start the tool, simply pull the switch trigger. Tool speedis increased by increasing pressure on the switch trigger.Release the switch trigger to stop.For continuous operation, pull the switch trigger and thenpush in the lock button.To stop the tool from the locked position, pull the switchtrigger fully, then release it.NOTE:• Even with the switch on and motor running, the bitwill not rotate until you fit the point of the bit in thescrew head and apply forward pressure to engagethe clutch.1. Switch trigger2. Lock button1. Approx. 1mm(3/64")2. Locator1. Approx. 1mm(3/64")2. Locator1. Locking sleeve