Makita 6826 Instruction Manual

Also see for 6826: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita 6826 Instruction Manual Manual pdf 4 page image

4Anjo, Aichi, JAPANGEA010-1General Power Tool SafetyWarningsWARNING Read all safety warnings and allinstructions. Failure to follow the warnings andinstructions may result in electric shock, fire and/orserious injury.Save all warnings and instructions forfuture reference. GEB017-2SPECIFIC SAFETY RULESDO NOT let comfort or familiarity with product(gained from repeated use) replace strict adherenceto screwdriver safety rules. If you use this powertool unsafely or incorrectly, you can suffer seriouspersonal injury.1. Hold power tool by insulated grippingsurfaces, when performing an operationwhere the fastener may contact hidden wiringor its own cord. Fasteners contacting a "live"wire may make exposed metal parts of the powertool "live" and could give the operator an electricshock.2. Always be sure you have a firm footing.Be sure no one is below when using the tool inhigh locations.3. Hold the tool firmly.4. Keep hands away from rotating parts.5. Do not touch the bit or the workpieceimmediately after operation; they may beextremely hot and could burn your skin.SAVE THESE INSTRUCTIONS.WARNING:MISUSE or failure to follow the safety rules stated inthis instruction manual may cause serious personalinjury.FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function onthe tool.Depth adjustmentFig.1The depth can be adjusted by turning the locking sleeve.Turn it in "A" direction for less depth and in "B" directionfor more depth. One full turn of the locking sleeve equals1.5 mm change in depth.Adjust the locking sleeve so that the distance betweenthe tip of the locator and the screw head isapproximately 1 mm as shown in the figure. Drive a trialscrew into your material or a piece of duplicate material.If the depth is still not suitable for the screw, continueadjusting until you obtain the proper depth setting.Fig.2Switch actionFig.3CAUTION:• Before plugging in the tool, always check to seethat the switch trigger actuates properly andreturns to the "OFF" position when released.To start the tool, simply pull the switch trigger. Toolspeed is increased by increasing pressure on the switchtrigger. Release the switch trigger to stop.For continuous operation, pull the switch trigger andthen push in the lock button.To stop the tool from the locked position, pull the switchtrigger fully, then release it.NOTE:• Even with the switch on and motor running, the bitwill not rotate until you fit the point of the bit in thescrew head and apply forward pressure to engagethe clutch.Reversing switch actionFig.4CAUTION:• Always check the direction of rotation beforeoperation.• Use the reversing switch only after the tool comesto a complete stop. Changing the direction ofrotation before the tool stops may damage the tool.This tool has a reversing switch to change the directionof rotation. Move the reversing switch lever tothe position (A side) for clockwise rotation orthe position (B side) for counterclockwise rotation.