Adjusting the driving depthDepress the stopper plate as far as it will go.While keeping it in this position, turn theadjusting knob until the bit tip projectsapprox. 5 mm (3/16")from the stopper plate.Drive a trial screw. If the screw head projectsabove the surface of the workpiece, turn theadjusting knob in the Wdirection; if thescrew head is countersunk, turn the adjust-ing knob in the B direction.Approx. 5 mm (3/16")cCasingStopper plateAdjusting knobInstalling the screw stripInsert the screw strip through the screw guide. Then insert it through the feeder box untilthe first screw reaches the position next to the driving position.Screw guide p e d e r boxDriving positionRemoving the screw stripTo remove the screw strip, just pull it out inthe direction of the arrow.9

Makita 6831D Instruction Manual