TROUBLESHOOTINGBefore making a request for repairs, check a trouble for yourself. If any abnormality is found, control your machine according to the description of thismanual. Never tamper or dismount any part contrary to the description. For repairs, contact Authorized Service Agent or local dealership.State of abnormality Probable cause (malfunction) RemedyFailure to operate primer pump Push 7 to 10 times.Low pulling speed of starter rope Pull strongly.Lack of fuel Feed fuel.Clogged fuel filter CleanBroken fuel tube Straighten fuel tubeDeteriorated fuel Deteriorated fuel makes starting more difficult.Replace with new one. (Recommendedreplacement: 1 month)Excessive suction of fuel Set throttle lever from medium speed to highspeed, and pull starter handle until engine starts.If engine will not start still, remove spark plug,make electrode dry, and reassemble them as theyoriginally are. Then, start as specified.Detached plug cap Attach securelyContaminated spark plug CleanAbnormal clearance of spark plug Adjust clearanceOther abnormality of spark plug ReplaceAbnormal carburetor Make request for inspection and maintenance.Starter rope cannot be pulled Make request for inspection and maintenanceEngine does not startAbnormal drive system Make request for inspection and maintenanceInsufficient warm-up Perform warm-up operationChoke lever is set to “CLOSE” although engineis warmed up Set to “OPEN”Clogged fuel filter CleanContaminated or clogged air cleaner CleanAbnormal carburetor Make request for inspection and maintenanceAbnormal drive system Make request for inspection and maintenanceDetached throttle wire Attach securelyEngine stops soonEngine speed does not increaseDetached connector Attach securelyAbnormal electric system Make request for inspection and maintenance.Engine does not stop.When the engine does not start after warm-up operation:If there is no abnormality found for the check items, open the throttle by about 1/3 and start the engine.Run engine at idling, and set chokelever to CLOSE.19