Makita BLS712 Instruction Manual

Contents

9INSTALLATION Bench mountingWhen the tool is shipped, the handle is locked in the loweredposition by the stopper pin. Release the stopper pin by lower-ing the handle slightly and pulling the stopper pin.This tool should be bolted with two bolts to a level and stablesurface using the bolt holes provided in the tool’s base. Thiswill help prevent tipping and possible injury.FUNCTIONALDESCRIPTION CAUTION:• Always be sure that the tool is switched off and thebattery cartridge is removed before adjusting orchecking function on the tool.Installing or removing battery cartridge• Always switch off the tool before insertion or removal ofthe battery cartridge.• To remove the battery cartridge, withdraw it from the toolwhile sliding the button on the side of the cartridge.• To insert the battery cartridge, align the tongue on thebattery cartridge with the groove in the housing and slipit into place. Always insert it all the way until it locks inplace with a little click. If you can see the red part on theupper side of the button, it is not locked completely.Insert it fully until the red part cannot be seen. If not, itmay accidentally fall out of the tool, causing injury to youor someone around you.• Do not use force when inserting the battery cartridge. Ifthe cartridge does not slide in easily, it is not beinginserted correctly.1. Stopper Pin10021931. Bolt10021941. Button2. Battery cartridge3. Red part213001803