Makita BPJ140 Instruction Manual

Also see for BPJ140: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita BPJ140 Instruction Manual Manual pdf 6 page image

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off and thebattery cartridge is removed before adjusting orchecking function on the tool.Installing or removing battery cartridge123012510• Always switch off the tool before installing orremoving of the battery cartridge.• To remove the battery cartridge, slide it from the toolwhile sliding the button on the front of the cartridge.• To install the battery cartridge, align the tongue onthe battery cartridge with the groove in the housingand slip it into place. Always insert it all the wayuntil it locks in place with a little click. If you can seethe red indicator on the upper side of the button, it isnot locked completely. Install it fully until the redindicator cannot be seen. If not, it may accidentallyfall out of the tool, causing injury to you or someonearound you.• Do not use force when installing the batterycartridge. If the cartridge does not slide in easily, itis not being inserted correctly.Adjusting the depth of groove123 40126826 grooving depths can be preset according to the size ofbiscuit to be used.Refer to the table below for the correspondence betweenthe sizes marked on the stopper and the biscuit size.Fine adjustments to the grooving depth can be made byturning the adjusting screw after loosening the hex nut.This may become necessary after the blade has beenresharpened a few times.Size on stopper 0 10 20 S D MAXBiscuit size 0 10 20 - - -Depth of groove 8 mm 10 mm 12.3mm 14.7mm13 mm 20 mm** With the rubber spikes removed.012681Angle guideThe angle guide height can be moved up and down toadjust the position of the blade in relation to the top of theworkpiece.12 3 4567012497To adjust the angle guide height, loosen the lock leverdown and rotate the knob until the pointer points to thedesired scale graduation marked on the angle guide.1234012498Then tighten the lock lever up to secure the angle guide.The scale on the angle guide indicates the distance fromthe top of the workpiece to the center of the bladethickness.The angle guide is removable from the fence accordingto the need of your work. To remove the angle guide,loosen the lock lever and turn the knob clockwise until itcomes out of the upper end of the fence.FenceNOTE:• Remove the angle guide according to the need ofyour work when using the tool with the angle of thefence adjusted to other than 0 잧. When you need touse the angle guide under the above condition, besure to adjust the depth of groove to get a properdepth.1. Knob2. Down3. Up4. Center of bladethickness1. Lock lever2. Angle guide3. Knob4. Scale5. Pointer6. Tighten7. Loosen1. Pointer2. Stopper3. Adjusting screw4. Rubber spike1. Button2. Red indicator3. Battery cartridge