5ENGLISH (Original Instructions)Explanation of general viewSPECIFICATIONS• Due to our continuing programme of research and development, the specifications herein are subject to change withoutnotice.• Specifications may differ from country to country.• Weight, with battery cartridge, according to EPTA-Procedure 01/2003Intended use ENE033-1The tool is intended for screw driving in wood, metal andplastic.General Power Tool SafetyWarnings GEA010-1WARNING Read all safety warnings and allinstructions. Failure to follow the warnings andinstructions may result in electric shock, fire and/orserious injury.Save all warnings andinstructions for future reference.CORDLESS IMPACT DRIVERSAFETY WARNINGS GEB054-11. Hold power tool by insulated gripping surfaces,when performing an operation where the fastenermay contact hidden wiring. Fasteners contacting a“live” wire may make exposed metal parts of thepower tool “live” and could give the operator anelectric shock.2. Always be sure you have a firm footing. Be sureno one is below when using the tool in highlocations.3. Hold the tool firmly.4. Wear ear protectors.SAVE THESE INSTRUCTIONS.WARNING:DO NOT let comfort or familiarity with product (gainedfrom repeated use) replace strict adherence to safetyrules for the subject product.MISUSE or failure to follow the safety rules stated inthis instruction manual may cause serious personalinjury.IMPORTANT SAFETYINSTRUCTIONS ENC007-4FOR BATTERY CARTRIDGE1. Before using battery cartridge, read allinstructions and cautionary markings on (1)battery charger, (2) battery, and (3) product usingbattery.2. Do not disassemble battery cartridge.3. If operating time has become excessively shorter,stop operating immediately. It may result in a riskof overheating, possible burns and even anexplosion.4. If electrolyte gets into your eyes, rinse them outwith clear water and seek medical attention rightaway. It may result in loss of your eyesight.5. Do not short the battery cartridge:(1) Do not touch the terminals with anyconductive material.(2) Avoid storing battery cartridge in a containerwith other metal objects such as nails, coins,etc.1. Red part2. Button3. Battery cartridge4. Switch trigger5. Lamp6. Reversing switch lever7. Bit8. Sleeve9. Bit-piece10. Standard bolt11. Fastening torque12. Fastening time (S)13. Proper fastening torque14. High tensile bolt15. Limit mark16. Rear cover17. Screws18. Spring19. Arm20. Recessed part21. Carbon brush cap22. HoleModel BTD125 BTD143CapacitiesMachine screw 4 mm - 8 mmStandard bolt 6 mm - 16 mmHigh tensile bolt 6 mm - 12 mmNo load speed (min -1 ) 0 - 2,300Impacts per minute 0 - 3,200Overall length 153 mmNet weight 1.4 kg 1.5 kgRated voltage D.C.14.4 V