52. Do not disassemble battery cartridge.3. If operating time has become excessivelyshorter, stop operating immediately. It mayresult in a risk of overheating, possible burnsand even an explosion.4. If electrolyte gets into your eyes, rinse themout with clear water and seek medicalattention right away. It may result in loss ofyour eyesight.5. Always cover the battery terminals with thebattery cover when the battery cartridge is notused.6. Do not short the battery cartridge:(1) Do not touch the terminals with anyconductive material.(2) Avoid storing battery cartridge in acontainer with other metal objects such asnails, coins, etc.(3) Do not expose battery cartridge to wateror rain.A battery short can cause a large currentflow, overheating, possible burns andeven a breakdown.7. Do not store the tool and battery cartridge inlocations where the temperature may reach orexceed 50 ゚ C (122 ゚ F).8. Do not incinerate the battery cartridge even ifit is severely damaged or is completely wornout. The battery cartridge can explode in a fire.9. Be careful not to drop or strike battery.10. Do not use dropped or struck battery.SAVE THESE INSTRUCTIONS.Tips for maintaining maximum battery life1. Charge the battery cartridge beforecompletely discharged.Always stop tool operation and charge thebattery cartridge when you notice less toolpower.2. Never recharge a fully charged batterycartridge.Overcharging shortens the battery service life.3. Charge the battery cartridge with roomtemperature at 10 ゚ C - 40 ゚ C (50 ゚ F - 104 ゚ F).Let a hot battery cartridge cool down beforecharging it.4. Charge the Nickel Metal Hydride batterycartridge when you do not use it for more thansix months.FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off and thebattery cartridge is removed before adjusting orchecking function on the tool.Installing or removing battery cartridge123008329• Always switch off the tool before insertion orremoval of the battery cartridge.• To remove the battery cartridge, withdraw it fromthe tool while sliding the button on the front of thecartridge.• To insert the battery cartridge, align the tongue onthe battery cartridge with the groove in the housingand slip it into place. Always insert it all the wayuntil it locks in place with a little click. If you cansee the red part on the upper side of the button, itis not locked completely. Insert it fully until the redpart cannot be seen. If not, it may accidentally fallout of the tool, causing injury to you or someonearound you.• Do not use force when inserting the batterycartridge. If the cartridge does not slide in easily, itis not being inserted correctly.Switch actionCAUTION:• Before inserting the battery cartridge into the tool,always check to see that the switch triggeractuates properly and returns to the "OFF" positionwhen released.1008330To start the tool, simply pull the switch trigger. Toolspeed is increased by increasing pressure on the switch1. Switch lever1. Red part2. Button3. Battery cartridge