Makita CL108FD Instruction Manual

Also see for CL108FD: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

12 ENGLISHOverloaded:The tool is operated in a manner that causes it to drawan abnormally high current.In this situation, turn the tool off and stop the applicationthat caused the tool to become overloaded. Then turnthe tool on to restart.Low battery voltage:The remaining battery capacity is too low and the toolwill not operate. If you turn the tool on, the motor runsagain but stops soon. In this situation, remove andrecharge the battery.Indicating the remaining batterycapacityOnly for battery cartridges with the indicator► Fig.3: 1. Indicator lamps 2. Check buttonPress the check button on the battery cartridge to indi-cate the remaining battery capacity. The indicator lampslight up for a few seconds.Indicator lamps RemainingcapacityLighted Off75% to 100%50% to 75%25% to 50%0% to 25%NOTE: Depending on the conditions of use and theambient temperature, the indication may differ slightlyfrom the actual capacity.Switch action► Fig.4: 1. ON/speed change button 2. OFF buttonTo start the cleaner, simply push the ON/speed changebutton. To switch off, push the OFF button.You can change the cleaner speed in three steps bypushing the ON/speed change button.The first push on this button is for high speed mode, thesecond push for max speed mode and the third push fornormal speed mode. Each push on this button repeatsthe high/max/normal speed cycle alternatively.Lighting up the lampCAUTION: Do not look in the light or see thesource of light directly.► Fig.5: 1. ON/speed change button 2. OFF button3. LampTo turn on the lamp, push the ON/speed change button.Push the OFF button to turn off the lamp. During thetool actuating, the lamp turns on.When the remaining battery capacity gets low, the lampstarts blinking.NOTE: The timing, at which the lamp starts blinking,depends on the temperature at work place and thebattery cartridge conditions.ASSEMBLYCAUTION: Always be sure that the tool isswitched off and the battery cartridge is removedbefore carrying out any work on the tool.Type of filterNormal filter► Fig.6: 1. Capsule 2. Prefilter 3. FilterHigh performance filter► Fig.7: 1. Capsule 2. High performance filterDisposing of dustCAUTION: Empty the cleaner before itbecomes too full, or the suction force weakens.CAUTION: Be sure to empty the inside of thecleaner itself of dust. Failure to do so may cause thefilter to be clogged or the motor to be damaged.Disposing of dust for normal filterIn order to drop dust sticking on the filter in the capsule,tap the capsule 4 or 5 times with your hand.► Fig.8: 1. Capsule 2. Suction inletPoint the suction inlet downwards, turn the capsule indirection of the arrow as illustrated, and disconnect thecapsule slowly and straight.► Fig.9: 1. Capsule 2. Suction inletNOTE: Be sure to set a garbage bag beneath thecapsule, as dust may spill out when the capsule isopened.Remove accumulated dust from inside of the capsuleand off of the prefilter.► Fig.10: 1. Prefilter 2. CapsuleTwist the prefilter in direction of the arrow to unfastenthe securing lip from the cleaner unit and then pull offthe prefilter.► Fig.11: 1. Prefilter 2. Securing lipClean out fine dust from the prefilter. And then, pull offthe filter and lightly tap it to remove dust.► Fig.12: 1. Filter 2. Prefilter