Makita DBC340 Instruction Manual

16REPAIR AND MAINTENANCE WORKCAUTION: Before doing any work on the brushcutter,always switch off the motor and pull the plugcap off the spark plug . Always wear protec-tive gloves!CAUTION: Start the brushcutter only after completeassembly and inspection!Sharpening of cutting toolsDNote: The cutting tools below should be sharpened only ata qualified workshop! Manual resharpening will result inan imbalance of the cutting tool, causing vibrations andengine damage.ï 4-tooth star bladeï 8-tooth eddy bladeï Steel bush cutterExpert sharpening can be obtained from a MAKITA servicestation.Note: To prolong its useful lifetime, the 4-tooth star blade canbe turned once until both cutting sides are blunt.General The brushcutter Clean exterior, check for damage. In case of damage,as a whole have repaired by a qualified service centre immediatelyBefore each start Cutting tool Check for any signs of damage, that the tool is sharp 11and that it is firmly secured.Screws and nuts Check their condition and that they are firmly secured. 10,11,12OFF switch, 18,19Safety locking button,Throttle lever Functional check 15Fuel tank plug Check for tightnessIdling speed Check, the cutting tool must not turn when the engine is idling. 15Every time after the Air filter Clean 18brushcutter is Clean frequently if working in extremely dusty conditions.switched off Cooling slit Clean, check for any signs of damage. 9Every week Starter cable Check for any signs of damage. 17Spark plug Check and replace if necessary 18Every 3 months Suction head Replace 19Fuel tank CleanAnnually The brushcutteras a whole Check at an authorized service centrelf the brushcutter is The brushcutter Have a maintenance check carried out at a MAKITA 8not to be used for a as a whole service centre. Store safely in a dry room. 8long period of timeFuel tank Empty and clean 8Carburetor Run empty 8Metal cutting tools Clean and lubricate lightlyUse the tool protectionPageInstructions for maintenanceFor long life and trouble-free operation of your brushcutter the maintenance work listed below must be carried out regularly. Failureto perform this maintenance work in a correct and timely fashion will void the guarantee. Failure to perform the prescribed mainte-nance work can lead to accidents!Do not do any maintenance or servicing work not described in this Instruction Manual. All such work may be done only by a MAKITAservice station.After refuelling the brushcutter 50 times, it should be given a thorough maintenance check and a complete inspection at a MAKITAservice centre.