Makita DBN500 Instruction Manual

Also see for DBN500: Instruction manual Instruction manual Instruction manual Instruction manual Technical information

Contents

Makita DBN500 Instruction Manual Manual pdf 7 page image

7Nailing mode selection1 23014618The tool has two different nailing modes. Select thedesired nailing by the mode selecting button. For moredetail, see the section "OPERATION".Intermittent nailing (sequential mode)This mode suits for driving a nail carefully andaccurately.Continuous/ intermittent nailing (continuous mode)When the tool is set to this mode, you can choose eithercontinuous or intermittent nailing by sequences of thetrigger operation.Adjusting the nailing depthWARNING:• Always make sure that your fingers are not placedon the trigger, and the battery cartridge and nailsare removed.A B1A B014601To get shallower depth, turn the adjuster to A directionas shown in the figure. To get deeper depth, turn theadjuster to B direction.Do not turn the adjuster too much, or the adjuster mayget stuck.Lighting up the lampCAUTION:• Do not look in the light or see the source of lightdirectly.123014600To turn on the lamp, pull the trigger or place the contactelement against the workpiece. Release the trigger orcontact element to turn it off.The lamp goes out 10 seconds after releasing thetrigger or contact element from the workpiece.NOTE:• Use a dry cloth to wipe the dirt off the lens of lamp.Be careful not to scratch the lens of lamp, or itmay lower the illumination.• Even in the lamp lights up when the battery powerresidual gets small, the nailer may not fire nails. Inthis case, charge the battery cartridge.ASSEMBLYCAUTION:• Always make sure that your fingers are not placedon the trigger, and the battery cartridge and nailsare removed before carrying out any work on thenailer.Loading or unloading the nailsCAUTION:• Always make sure that your fingers are not placedon the trigger and the battery cartridge is removedbefore loading nails.• Do not abruptly slide the slide door of the nailerloaded with nails. Accidentally dropping nailsespecially when working in high places may causepersonal injuries.• Load nails in the correct direction. Loading inwrong direction may cause premature wear andtear of the driver and damage of the other parts.• Do not use deformed connected nails. Use nailsspecified in this manual. Using nails other thanthose specified may cause nail jamming andbreakage of the nailer.1. Lamp2. Trigger3. Driver guide(contactelement)1. Adjuster1. Mode selectingbutton2. Sequentialmode3. Continuousmode