7OPERATING INSTRUCTIONS2. Inserting screwdriver bitsTo insert a screwdriver bit, push it firmly into the screwdriver bit holder. See figures 2 & 3.To remove a screwdriver bit, pull it firmly out of the screwdriver bit holder.If required the magnetic bit holder supplied with the screwdriver, can be inserted into the screwdriver bit holder and thescrewdriver bit can then be inserted into the magnetic bit holder.3. Operating the On/Off switchThe On/Off switch is used to start the screwdriver. It also controls the direction in which the bit holder rotates.1. To rotate the bit holder in a forward (driving) direction, press the right hand side of the On/Off switch marked . Seefigure 4.2. To rotate the bit holder in a reverse (removing screws) direction, press the left hand side of the On/Off switch marked. See figure 5.3. Release the On/Off switch to stop the screwdriver.WARNING!Do not press the On/Off switch when removing, or installing a screwdriver bit.WARNING!Before operating the On/Off switch, make sure that you have read all of the safety instructions onpages 3 and 5.2 3Forward(Driving)4Reverse(Removing screws)5