Makita DF011D Instruction Manual

Also see for DF011D: Instruction manual

Contents

Makita DF011D Instruction Manual Manual pdf 7 page image

71. SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions forbattery charger.2. Before using battery charger, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3)product using battery.3. CAUTION – To reduce risk of injury, charge only MAKITA rechargeable batteries. Other types of batteries may burstcausing personal injury and damage.4. Non-rechargeable batteries cannot be charged with this battery charger.5. Use a power source with the voltage specified on the nameplate of the charger.6. Do not charge the battery cartridge in presence of flammable liquids or gases.7. Do not expose charger to rain or snow.8. Never carry charger by cord or yank it to disconnect from receptacle.9. After charging or before attempting any maintenance or cleaning, unplug the charger from the power source. Pull byplug rather than cord whenever disconnecting charger.10. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.11. Do not operate charger with damaged cord or plug – replace them immediately.12. Do not operate or disassemble charger if it has received a sharp blow, been dropped, or otherwise damaged in anyway; take it to a qualified serviceman. Incorrect use or reassembly may result in a risk of electric shock or fire.13. The battery charger is not intended for use by young children or infirm persons without supervision.14. Young children should be supervised to ensure that they do not play with the battery charger.15. Do not charge battery cartridge when temperature is BELOW 10°C or ABOVE 40°C.16. Do not attempt to use a step-up transformer, an engine generator or DC power receptacle.NOTE:• The battery charger is for charging Makita battery cartridge. Never use it for other purposes or for other manufacturer’sbatteries.• If you charge a battery cartridge from a just operated tool or a battery cartridge which has been exposed to directsunlight or heat for a long time, the charging light may flash in red color. If this occurs, wait for a while. Charging willbegin after the battery cartridge cools.• If the charging light flashes alternately in green and red, charging is not possible. The terminals on the charger orbattery cartridge are clogged with dust or the battery cartridge is worn out or damaged.OPERATING INSTRUCTIONS2. Inserting screwdriver bitsTo insert a screwdriver bit, push it firmly into the screwdriver bit holder. See figures 2 & 3.To remove a screwdriver bit, pull it firmly out of the screwdriver bit holder.If required the magnetic bit holder supplied with the screwdriver, can be inserted into the screwdriver bit holder and thescrewdriver bit can then be inserted into the magnetic bit holder.This cordless screwdriver is supplied with an 80 piece accessory pack. See page 3 for details.NOTE:Replacement screwdriver bits can be obtained from most tool or DIY stores.WARNING!Do not press the On/Off switch when removing, or installing a screwdriver bit.WARNING!Before operating the On/Off switch, make sure that you have read all of the safety instructions onpages 4 and 5.2 3