Makita DHS680 Instruction Manual

Also see for DHS680: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita DHS680 Instruction Manual Manual pdf 9 page image

9Releasing protection lockWhen the protection system works repeatedly, the toolis locked and the battery indicator shows the followingstate.Battery indicator On Off BlinkingProtection lock works015201In this situation, the tool does not start even if turningthe tool off and on. To release the protection lock,remove the battery, set it to the battery charger and waituntil the charging finishes.Adjusting depth of cutCAUTION:• After adjusting the depth of cut, always tighten thelever securely.12015198Loosen the lever on the side of the rear handle andmove the base up or down. At the desired depth of cut,secure the base by tightening the lever.For cleaner, safer cuts, set cut depth so that no morethan one blade tooth projects below workpiece. Usingproper cut depth helps to reduce potential for dangerousKICKBACKS which can cause personal injury.Bevel cutting1015105Loosen the front lever. Set for the desired angle (0° -50°) by tilting accordingly, then tighten the front leversecurely.10-450-50015116Use the 45° stopper when you do precise 45° anglecutting. Turn the stopper counterclockwise fully for bevelcut (0° - 45°) and turn it clockwise for 0° - 50° bevel cuts.Sighting1 23015106For straight cuts, align the 0° position on the front of thebase with your cutting line. For 45° bevel cuts, align the 45°position with it. The position of the top guide is adjustable.Lighting the lampCAUTION:• Do not look in the lamp or see the source of lamp directly.1015154Only to turn on the lamp, pull the switch trigger withoutpressing the lock-off lever. To turn on the lamp and runthe tool, press the lock-off lever and pull the switchtrigger with pressing the lock-off lever. The lamp keepson lighting while the switch trigger is being pulled. Thelamp goes out 10 -15 seconds after releasing the trigger.NOTE:• Use a dry cloth to wipe the dirt off the lens of lamp.Be careful not to scratch the lens of lamp, or itmay lower the illumination.• Do not use gasoline, thinner or the like to cleanthe lens of lamp. Using such substances willdamage the lens.1. Lamp1. Cutting line(0 ﾟ position)2. Cutting line(45 ﾟ position)3. Screw1. Stopper1. Front lever1. Lever2. Depth guide