8123001910Return the tool opener to its original position.After installing, always make sure that the blade issecurely held in place by trying to pull it out.CAUTION:• Do not open the tool opener excessively, or it maycause tool damage.To remove the blade, open the tool opener to the positionshown in the figure. Pull the saw blade out toward thebase.1001911NOTE:• Occasionally lubricate the roller.Hex wrench storage12007486When not in use, store the hex wrench as shown in thefigure to keep it from being lost.Cover plate12007503Use the cover plate when cutting decorative veneers,plastics, etc. It protects sensitive or delicate surfacesfrom damage. Fit it on the back of the tool base.Anti-splintering device12007504For splinter-free cuts, the anti-splintering device can beused. To install the anti-splintering device, move the toolbase all the way forward and fit it from the back of toolbase. When you use the cover plate, install theanti-splintering device onto the cover plate.CAUTION:• The anti-splintering device cannot be used whenmaking bevel cuts.Dust extractionThe dust nozzle (optional accessory) is recommended toperform clean cutting operations.12001921To attach the dust nozzle on the tool, insert the hook ofdust nozzle into the hole in the base.The dust nozzle can be installed on either left or rightside of the base.1. Dust nozzle2. Base1. Base2. Anti-splinteringdevice1. Cover plate2. Base1. Base2. Hex wrench1. Jig saw blade1. Blade clamp2. Jig saw blade3. Protrusions