Makita DRT52 Instruction Manual
Also see for DRT52: Instruction manualInstruction manualInstruction manual
                                                                            |
16 ENGLISHNOTE: The workpiece will be cut a slightly differentsize from the templet. Allow for the distance (X)between the trimmer bit and the outside of the templetguide. The distance (X) can be calculated by usingthe following equation:Distance (X) = (outside diameter of the templetguide - trimmer bit diameter) / 2Straight guideThe straight guide is effectively used for straight cutswhen chamfering.► Fig.341. Attach the guide plate to the straight guide withthe bolt and the wing nut.► Fig.35: 1. Bolt 2. Guide plate 3. Straight guide4. Wing nut2. Remove the trimmer shoe from the tilt base.Loosen the wing bolts, secure the base horizontally, andthen attach the straight guide with the clamping screw.► Fig.36: 1. Clamping screw 2. Straight guide 3. Wingnut 4. Base 5. Wing bolt3. Loosen the wing nut on the straight guide andadjust the distance between the trimmer bit and thestraight guide. At the desired distance, tighten the wingnut securely.4. When cutting, move the tool with the straight guideflush with the side of the workpiece.Trimmer guideTrimming, curved cuts in veneers for furniture and thelike can be done easily with the trimmer guide. Theguide roller rides the curve and assures a fine cut.► Fig.371. Remove the trimmer shoe from the tilt base.Loosen the wing bolts and secure the base horizontally.2. Install the trimmer guide and guide holder on thebase with the clamping screw (A).3. Loosen the clamping screw (B) and adjust thedistance between the trimmer bit and the trimmer guideby turning the adjusting screw (1 mm per turn). At thedesired distance, tighten the clamping screw (B) tosecure the trimmer guide in place.► Fig.38: 1. Adjusting screw 2. Guide holder3. Trimmer guide 4. Wing bolt4. When cutting, move the tool with the guide rollerriding the side of the workpiece.► Fig.39: 1. Workpiece 2. Trimmer bit 3. Guide rollerMAINTENANCECAUTION: Always be sure that the tool isswitched off and the battery cartridge is removedbefore attempting to perform inspection ormaintenance.NOTICE: Never use gasoline, benzine, thinner,alcohol or the like. Discoloration, deformation orcracks may result.To maintain product SAFETY and RELIABILITY,repairs, any other maintenance or adjustment shouldbe performed by Makita Authorized or Factory ServiceCenters, always using Makita replacement parts.TRIMMER BITSOptional accessoryStraight bit► Fig.40U-grooving bit► Fig.41V-grooving bit► Fig.42Drill point flush trimming bit► Fig.43Drill point double flush trimming bit► Fig.44Corner rounding bit► Fig.45Chamfering bit► Fig.46Cove beading bit► Fig.47Ball bearing flush trimming bit► Fig.48Ball bearing beading bit► Fig.49Ball bearing corner rounding bit► Fig.50Ball bearing chamfering bit► Fig.51Ball bearing cove beading bit► Fig.52Ball bearing roman ogee bit► Fig.53 |
Related manuals for Makita DRT52
Makita DRT52 Instruction Manual
Makita DRT52 Instruction Manual
Makita DRT52 Instruction Manual
Makita DRT50 Instruction Manual
Makita DRT50 Instruction Manual
Makita DRT50 Instruction Manual
Makita DRT50 Instruction Manual
Makita DRT50 Instruction Manual
Makita DRT50 Instruction Manual
Makita DRT50 Instruction Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine