Makita DSP600 Instruction Manual

Also see for DSP600: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita DSP600 Instruction Manual Manual pdf 9 page image

9 ENGLISHENGLISH (Original instructions)SPECIFICATIONSModel: DSP600 DSP601Blade diameter 165 mmMax. Cutting depth at 0° 56 mmat 45° bevel 40 mmat 48° bevel 38 mmNo load speed 2,500 - 6,300 min -1Overall length 346 mmRated voltage D.C. 36 VBattery cartridge BL1815N, BL1820, BL1820B, BL1830, BL1830B, BL1840,BL1840B, BL1850, BL1850B, BL1860BCharger DC18RC, DC18RD, DC18SD, DC18SE, DC18SFNet weight 4.4 - 5.1 kg• Due to our continuing program of research and development, the specifications herein are subject to changewithout notice.• Specifications and battery cartridge may differ from country to country.• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-est combination, according to EPTA-Procedure 01/2014, are shown in the table.Intended useThe tool is specially intended for performing plungecuts. The tool is also intended for rip and cross cuts inwood. If the tool is equipped with proper circular sawblade, the tool can be used for sawing aluminum, plas-tic, mineral contained plastic, and similar materials.NoiseThe typical A-weighted noise level determined accord-ing to EN62841:Model DSP600Sound pressure level (L pA ) : 92 dB(A)Sound power level (LWA ) : 103 dB (A)Uncertainty (K) : 3 dB(A)Model DSP601Sound pressure level (L pA ) : 92 dB(A)Sound power level (LWA ) : 103 dB (A)Uncertainty (K) : 3 dB(A)WARNING: Wear ear protection.VibrationThe vibration total value (tri-axial vector sum) deter-mined according to EN62841:Model DSP600Work mode: cutting woodVibration emission (ah,W) : 2.5 m/s2 or lessUncertainty (K) : 1.5 m/s2Work mode: cutting metalVibration emission (ah,M) : 2.5 m/s2 or lessUncertainty (K) : 1.5 m/s2Model DSP601Work mode: cutting woodVibration emission (ah,W) : 2.5 m/s2 or lessUncertainty (K) : 1.5 m/s2Work mode: cutting metalVibration emission (ah,M) : 2.5 m/s2 or lessUncertainty (K) : 1.5 m/s2NOTE: The declared vibration emission value hasbeen measured in accordance with the standard testmethod and may be used for comparing one tool withanother.NOTE: The declared vibration emission valuemay also be used in a preliminary assessment ofexposure.WARNING: The vibration emission during actualuse of the power tool can differ from the declaredemission value depending on the ways in which thetool is used.WARNING: Be sure to identify safety measuresto protect the operator that are based on an estima-tion of exposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when it isrunning idle in addition to the trigger time).EC Declaration of ConformityFor European countries onlyThe EC declaration of conformity is included as Annex Ato this instruction manual.