Makita DTD153 Instruction Manual

Also see for DTD153: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

7 ENGLISHFor tool with shallow driver bit holeA=12mmB=9mmUse only these type of driverbit. Follow the procedure1. (Note) Bit-piece is notnecessary.For tool with deep driver bit holeA=17mmB=14mmTo install these types of driverbits, follow the procedure 1.A=12mmB=9mmTo install these types of driverbits, follow the procedure 2.(Note) Bit-piece is necessaryfor installing the bit.Procedure 1For tool without one-touch type sleeve► Fig.8: 1. Driver bit 2. SleeveTo install the driver bit, pull the sleeve in the direction ofthe arrow and insert the driver bit into the sleeve as faras it will go.Then release the sleeve to secure the driver bit.For tool with one-touch type sleeveTo install the driver bit, insert the driver bit into thesleeve as far as it will go.Procedure 2In addition to Procedure 1, insert the bit-piece into thesleeve with its pointed end facing in.► Fig.9: 1. Driver bit 2. Bit-piece 3. SleeveTo remove the driver bit, pull the sleeve in the directionof the arrow and pull the driver bit out.NOTE: If the driver bit is not inserted deep enoughinto the sleeve, the sleeve will not return to its originalposition and the driver bit will not be secured. In thiscase, try re-inserting the bit according to the instruc-tions above.NOTE: When it is difficult to insert the driver bit, pullthe sleeve and insert it into the sleeve as far as it willgo.NOTE: After inserting the driver bit, make sure that itis firmly secured. If it comes out, do not use it.Installing hook► Fig.10: 1. Groove 2. Hook 3. ScrewThe hook is convenient for temporarily hanging the tool.This can be installed on either side of the tool. To installthe hook, insert it into a groove in the tool housing oneither side and then secure it with a screw. To remove,loosen the screw and then take it out.OPERATION► Fig.11The proper fastening torque may differ depending uponthe kind or size of the screw/bolt, the material of theworkpiece to be fastened, etc. The relation between fas-tening torque and fastening time is shown in the figures.Proper fastening torque for standard bolt140N•m(kgf•cm)(1428)120(1224)100(1020)80(816)60(612)40(408)20(204)0M16M10M8M14M12(M16)(M14)(M12)(M10)(M8)212.01.01. Fastening time (second) 2. Fastening torqueProper fastening torque for high tensile bolt21200(2040)N•m(kgf•cm)180(1836)160(1632)140(1428)120(1224)100(1020)80(816)60(612)40(408)20(204)0M14M12(M14)(M12)(M10)(M8)M10M82.0 3.01.01. Fastening time (second) 2. Fastening torqueHold the tool firmly and place the point of the driver bitin the screw head. Apply forward pressure to the tool tothe extent that the bit will not slip off the screw and turnthe tool on to start operation.