Makita DTD154 Instruction Manual

Also see for DTD154: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

6 ENGLISHOverheat protectionWhen the tool/battery is overheated, the tool stopsautomatically. In this situation, let the battery coolbefore turning the tool on again.Overdischarge protectionWhen the battery capacity is not enough, the tool stopsautomatically. In this case, remove the battery from thetool and charge the battery.NOTE: Overload protection will work only with batter-ies with star marking.1► 1. Star markingSwitch action1► 1. Switch triggerCAUTION: Before installing the battery car-tridge into the tool, always check to see that theswitch trigger actuates properly and returns tothe "OFF" position when released.To start the tool, simply pull the switch trigger. Toolspeed is increased by increasing pressure on the switchtrigger. Release the switch trigger to stop.NOTE: The tool automatically stops if you keep pull-ing the switch trigger for about 6 minutes.Lighting up the front lampCAUTION: Do not look in the light or see thesource of light directly.1► 1. Lamp1► 1. ButtonPull the switch trigger to turn on the lamp. To turn off,release it. The lamp goes out approximately 10 secondsafter releasing the switch trigger.To keep the lamp off, turn off the lamp status. To turn offthe lamp status, first pull and release the switch trigger.And then press the button for one second within 10seconds.To turn on the lamp status again, press the button againsimilarly.NOTE: To confirm the lamp status, pull the trigger.When the lamp lights up by pulling the switch trigger,the lamp status is ON. When the lamp does not comeon, the lamp status is OFF.NOTE: When the tool is overheated, the light flashesfor one minute, and then the LED display goes off. Inthis case, cool down the tool before operating again.NOTE: Use a dry cloth to wipe the dirt off the lens ofthe lamp. Be careful not to scratch the lens of lamp, orit may lower the illumination.