Makita DTD172 Instruction Manual

Also see for DTD172: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

13 ENGLISHIndication patternsApplication mode While registering the application mode When the registered application modeturns on4 (Max)3 (Hard)2 (Medium)1 (Soft)Wood modeBolt modeT mode (1)T mode (2): The lamp is on.: The lamp is blinking.ASSEMBLYCAUTION: Always be sure that the tool isswitched off and the battery cartridge is removedbefore carrying out any work on the tool.Installing or removing driver bit/socket bit► Fig.12Use only driver bit/socket bit that has inserting portionshown in the figure. Do not use any other driver bit/socket bit.For tool with shallow driver bit holeA=12mmB=9mmUse only these type of driverbit. Follow the procedure1. (Note) Bit-piece is notnecessary.For tool with deep driver bit holeA=17mmB=14mmTo install these types of driverbits, follow the procedure 1.A=12mmB=9mmTo install these types of driverbits, follow the procedure 2.(Note) Bit-piece is necessaryfor installing the bit.Procedure 1For tool without one-touch type sleeve► Fig.13: 1. Driver bit 2. SleeveTo install the driver bit, pull the sleeve in the direction ofthe arrow and insert the driver bit into the sleeve as faras it will go.Then release the sleeve to secure the driver bit.For tool with one-touch type sleeveTo install the driver bit, insert the driver bit into thesleeve as far as it will go.Procedure 2In addition to Procedure 1, insert the bit-piece into thesleeve with its pointed end facing in.► Fig.14: 1. Driver bit 2. Bit-piece 3. Sleeve