Makita DTW180Z Instruction Manual

Also see for DTW180: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

2 ENGLISHSPECIFICATIONSModel: DTW180Fastening capacities Standard bolt M8 - M16High tensile bolt M6 - M12Square drive 9.5 mmNo load speed Hard impact mode 0 - 2,400 min -1Soft impact mode 0 - 1,300 min -1Impacts per minute Hard impact mode 0 - 3,600 min -1Soft impact mode 0 - 2,000 min -1Overall length 144 mmRated voltage D.C. 18 VNet weight 1.2 - 1.5 kg• Due to our continuing program of research and development, the specifications herein are subject to changewithout notice.• Specifications may differ from country to country.• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-est combination, according to EPTA-Procedure 01/2014, are shown in the table.Applicable battery cartridge and chargerBattery cartridge BL1815N / BL1820 / BL1820B / BL1830 / BL1830B / BL1840 /BL1840B / BL1850 / BL1850B / BL1860BCharger DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF• Some of the battery cartridges and chargers listed above may not be available depending on your region ofresidence.WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridgesand chargers may cause injury and/or fire.SymbolsThe following show the symbols used for the equipment.Be sure that you understand their meaning before use.Read instruction manual.Ni-MHLi-ionOnly for EU countriesDo not dispose of electric equipment or batterypack together with household waste material!In observance of the European Directives,on Waste Electric and ElectronicEquipment and Batteries and Accumulatorsand Waste Batteries and Accumulatorsand their implementation in accordancewith national laws, electric equipment andbatteries and battery pack(s) that havereached the end of their life must be col-lected separately and returned to an envi-ronmentally compatible recycling facility.Intended useThe tool is intended for fastening bolts and nuts.NoiseThe typical A-weighted noise level determined accord-ing to EN62841-2-2:Sound pressure level (LpA) : 89 dB(A)Sound power level (LWA) : 100 dB (A)Uncertainty (K) : 3 dB(A)WARNING: Wear ear protection.VibrationThe vibration total value (tri-axial vector sum) deter-mined according to EN62841-2-2:Work mode: impact tightening of fasteners of the maxi-mum capacity of the toolVibration emission (ah) : 9.0 m/s2Uncertainty (K) : 1.5 m/s2NOTE: The declared vibration emission value hasbeen measured in accordance with the standard testmethod and may be used for comparing one tool withanother.NOTE: The declared vibration emission valuemay also be used in a preliminary assessment ofexposure.WARNING: The vibration emission during actualuse of the power tool can differ from the declaredemission value depending on the ways in which thetool is used.WARNING: Be sure to identify safety measuresto protect the operator that are based on an estima-tion of exposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when it isrunning idle in addition to the trigger time).