Makita DTW190 Instruction Manual

Also see for DTW190: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

4 ENGLISHENGLISH (Original instructions)SPECIFICATIONSModel: DTW190Fastening capacities Standard bolt M8 - M16High tensile bolt M8 - M12Square drive 12.7 mmNo load speed 0 - 2,300 min -1Impacts per minute 0 - 3,000 min -1Overall length 176 mmRated voltage D.C. 18 VNet weight 1.4 - 1.8 kg• Due to our continuing program of research and development, the specifications herein are subject to changewithout notice.• Specifications may differ from country to country.• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-est combination, according to EPTA-Procedure 01/2014, are shown in the table.Applicable battery cartridge and chargerBattery cartridge BL1815N / BL1820 / BL1820B / BL1830 / BL1830B / BL1840 /BL1840B / BL1850 / BL1850B / BL1860BCharger DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF• Some of the battery cartridges and chargers listed above may not be available depending on your region ofresidence.WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridgesand chargers may cause injury and/or fire.Intended useThe tool is intended for fastening bolts and nuts.NoiseThe typical A-weighted noise level determined accord-ing to EN62841-2-2:Sound pressure level (LpA) : 94 dB(A)Sound power level (LWA) : 105 dB (A)Uncertainty (K) : 3 dB(A)WARNING: Wear ear protection.VibrationThe vibration total value (tri-axial vector sum) deter-mined according to EN62841-2-2:Work mode: impact tightening of fasteners of the maxi-mum capacity of the toolVibration emission (ah) : 8.5 m/s2Uncertainty (K) : 1.5 m/s2NOTE: The declared vibration emission value hasbeen measured in accordance with the standard testmethod and may be used for comparing one tool withanother.NOTE: The declared vibration emission valuemay also be used in a preliminary assessment ofexposure.WARNING: The vibration emission during actualuse of the power tool can differ from the declaredemission value depending on the ways in which thetool is used.WARNING: Be sure to identify safety measuresto protect the operator that are based on an estima-tion of exposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when it isrunning idle in addition to the trigger time).EC Declaration of ConformityFor European countries onlyThe EC declaration of conformity is included as Annex Ato this instruction manual.