Makita DTW281 Instruction Manual

Also see for DTW281: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita DTW281 Instruction Manual Manual pdf 5 page image

5FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off and thebattery cartridge is removed before adjusting orchecking function on the tool.Installing or removing battery cartridge12 3014636CAUTION:• Always switch off the tool before installing orremoving of the battery cartridge.• Hold the tool and the battery cartridge firmly wheninstalling or removing battery cartridge. Failure tohold the tool and the battery cartridge firmly may causethem to slip off your hands and result in damage to thetool and battery cartridge and a personal injury.To remove the battery cartridge, slide it from the toolwhile sliding the button on the front of the cartridge.To install the battery cartridge, align the tongue on thebattery cartridge with the groove in the housing and slipit into place. Insert it all the way until it locks in placewith a little click. If you can see the red indicator on theupper side of the button, it is not locked completely.CAUTION:• Always install the battery cartridge fully until thered indicator cannot be seen. If not, it mayaccidentally fall out of the tool, causing injury toyou or someone around you.• Do not install the battery cartridge forcibly. If thecartridge does not slide in easily, it is not beinginserted correctly.Battery protection system(Lithium-ion battery with star marking)1012128Lithium-ion batteries with a star marking are equippedwith a protection system. This system automatically cutsoff power to the tool to extend battery life.The tool will automatically stop during operation if the tooland/or battery are placed under one of the following conditions:• Overloaded:The tool is operated in a manner that causesit to draw an abnormally high current.In this situation, release the trigger switch onthe tool and stop the application that causedthe tool to become overloaded. Then pull thetrigger switch again to restart.If the tool does not start, the battery isoverheated. In this situation, let the batterycool before pulling the trigger switch again.• Low battery voltage:The remaining battery capacity is too lowand the tool will not operate. In this situation,remove and recharge the battery.Indicating the remaining battery capacity(Only for battery cartridges with "B" at the end of themodel number.)12015676Press the check button on the battery cartridge toindicate the remaining battery capacity. The indicatorlamps light up for few seconds.Off BlinkingLightedIndicator lampsCharge thebattery.0% to 25%25% to 50%50% to 75%75% to 100%RemainingcapacityThe batterymay havemalfunctioned.0156581. Indicator lamps2. CHECK button1. Star marking1. Red indicator2. Button3. Battery cartridge