Makita DUB362 Instruction Manual
Also see for DUB362: Instruction manualInstruction manualInstruction manualInstruction manualInstruction manual
                                                    | |
7Overheat protection for toolOn Blinking015485When the tool is overheated, the tool stopsautomatically, the battery indicator blink about 60seconds. In this situation, let the tool cool down beforeturning the tool on again.Overdischarge protectionWhen the battery capacity becomes low, the tool stopsautomatically. If the product does not operate evenwhen the switches are operated, remove the batteriesfrom the tool and charge the batteries.Remaining battery capacity indicationFig.2Press the check button to make the battery indicatorsshow the remaining battery capacities. The batteryindicators correspond to each battery.Remaining battery capacity indicationBattery indicator statusRemaining battery capacity50% - 100%20% - 50%0% - 20%Charge the batteryOn Off Blinking015527Switch actionCAUTION:• Before inserting the battery cartridge into the tool,always check to see that the switch triggeractuates properly and returns to the "OFF"position when released.Fig.3To start the tool, simply pull the switch trigger. Toolspeed is increased by increasing pressure on the switchtrigger. Release the switch trigger to stop.Fig.4For continuous operation, pull the switch trigger, push inthe lock button and then release the switch trigger.To stop the tool from the locked position, pull the switchtrigger fully, then release it.Speed changeFig.5The maximum air volume can be adjusted just byturning the adjusting dial. This can be done even whilethe tool is running. The dial is marked 1 (lowest) to 6(highest).NOTICE:The speed adjusting dial can be turned only as faras 6 and back to 1. Do not force it past 6 or 1, orthe speed adjusting function may no longer work.When working in a high temperature circumstance,the tool may be stopped because of the overheatprotection system. In that case let the tool cooldown. Avoid setting to speed 6 (highest) in hightemperature circumstances.ASSEMBLYCAUTION:• Always be sure that the tool is switched off and thebattery cartridge is removed before carrying outany work on the tool.Installing the long nozzleFig.6To install the long nozzle:1. Align the small projection of the housing with thegroove of the long nozzle.2. Slide in the long nozzle, and turn it clockwise untilthe triangle markings on the long nozzle and thehousing meet each other.Fig.7The length of the nozzle can be adjusted by changingthe locking position.Installing the shoulder strap(optional accessory)Fig.8Hook the shoulder strap onto the hanger of the tool.Before use, adjust the length of strap so that it is easy towork with it.OPERATIONBlowingFig.9CAUTION:• Do not place the blower on the ground while it isswitched on. Sand or dust may enter from suctioninlet, and they may result in personal injury.Hold the blower firmly with a hand and perform theblowing operation by moving it around slowly.When blowing around a building, a big stone or avehicle, direct the nozzle away from them.When performing an operation in corner, start from thecorner and then move to wide area. |
Related manuals for Makita DUB362
Makita DUB362 Instruction Manual
Makita DUB362 Instruction Manual
Makita DUB362 Instruction Manual
Makita DUB362 Instruction Manual
Makita DUB362 Instruction Manual
Makita DUB362 Instruction Manual
Makita DUB362 Instruction Manual
Makita DUB362 Instruction Manual
Makita DUB362 Instruction Manual
Makita DUB362 Instruction Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine