9 ENGLISHSaw chain type 25APNumber of drive links 60Guide bar Guide bar length 250 mmCutting length 250 mmPitch 1/4″Gauge 1.3 mmType Carving barSprocket Number of teeth 9Pitch 1/4″NOTICE: When using 25AP saw chain, use with Sprocket 9 (optional accessory).WARNING: Use appropriate combination of the guide bar and saw chain. Otherwise personal injury mayresult.SymbolsThe following show the symbols used for the equipment.Be sure that you understand their meaning before use.Read instruction manual.Wear safety glasses.Wear ear protection.Wear a helmet, goggles and ear protection.Use appropriate protection for foot-leg andhand-arm.This saw is to be used by properly trainedoperators only.Do not expose to moisture.Maximum permissible cut lengthAlways use two hands when operating thechain saw.Direction of chain travelSaw chain oil adjustmentNi-MHLi-ionOnly for EU countriesDo not dispose of electric equipment or batterypack together with household waste material!In observance of the European Directives,on Waste Electric and ElectronicEquipment and Batteries and Accumulatorsand Waste Batteries and Accumulatorsand their implementation in accordancewith national laws, electric equipment andbatteries and battery pack(s) that havereached the end of their life must be col-lected separately and returned to an envi-ronmentally compatible recycling facility.Intended useThe tool is intended for cutting branches and pruningtrees. It is also suitable for tree service.NoiseThe typical A-weighted noise level determined accord-ing to IEC62841-4-1:Model DUC204Sound pressure level (LpA) : 92.2 dB(A)Sound power level (LWA) : 103.2 dB (A)Uncertainty (K) : 2.5 dB(A)Model DUC254Sound pressure level (LpA) : 92.2 dB(A)Sound power level (LWA) : 103.2 dB (A)Uncertainty (K) : 2.5 dB(A)Model DUC254CSound pressure level (LpA) : 92.2 dB(A)Sound power level (LWA) : 103.2 dB (A)Uncertainty (K) : 2.5 dB(A)WARNING: Wear ear protection.VibrationThe vibration total value (tri-axial vector sum) deter-mined according to IEC62841-4-1:Model DUC204Work mode: cutting woodVibration emission (ah,W) : 3.1 m/s2Uncertainty (K) : 1.5 m/s2Model DUC254Work mode: cutting woodVibration emission (ah,W) : 3.1 m/s2Uncertainty (K) : 1.5 m/s2Model DUC254CWork mode: cutting woodVibration emission (ah,W) : 4.1 m/s2Uncertainty (K) : 1.5 m/s2NOTE: The declared vibration emission value has beenmeasured in accordance with the standard test methodand may be used for comparing one tool with another.NOTE: The declared vibration emission value mayalso be used in a preliminary assessment of exposure.