9123012485As a basic operation, tilt the blades towards thetrimming direction and move it calmly and slowly at thespeed rate of 3 - 4 seconds per meter.1012486To cut a hedge top evenly, it helps to tie a string at thedesired hedge height and to trim along it, using it as areference line.012487Attaching the chip receiver (optional accessory) on thetool when trimming the hedge straight can avoid cut offleaves’ being thrown away.012488To cut a hedge side evenly, it helps to cut from thebottom upwards.012489Trim boxwood or rhododendron from the base towardthe top for a nice appearance and good job.Installing or removing chip receiver(optional accessory)CAUTION:• Always be sure that the tool is switched off andunplugged before installing or removing chipreceiver.NOTE:• When replacing the chip receiver, always weargloves so that hands and face does not directlycontact the blade. Failure to do so may causepersonal injury.• Always be sure to remove the blade cover beforeinstalling the chip receiver.• The chip receiver receives cut-off leaves andalleviates collecting thrown-away leaves. This canbe installed on either side of the tool.1234012493Press the chip receiver on the shear blades so that itsslits overlap with the nuts on the shear blades.11223 3012494At this time, the chip receiver needs to be installed sothat its hooks fit into grooves in the shear blade unit.1. Hooks2. Fit the hooksinto groove3. Grooves1. Press2. Chip receiver3. Nut4. Shear blade1. String1. Trimmingdirection2. Hedge surfaceto be trimmed3. Tilt the blades