Makita DWR180RA Instruction Manual

Also see for DWR180: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

4 ENGLISHENGLISH (Original instructions)SPECIFICATIONSModel: DWR180Fastening capacities(with manual retightening)Standard bolt M5 - M12High tensile bolt M5 - M10Square drive 6.35 mm, 9.5 mmNo load speed 0 - 800 min -1Maximum fastening torque 47.5 N•mOverall length 369 mmRated voltage D.C. 18 VNet weight 1.2 - 1.6 kg• Due to our continuing program of research and development, the specifications herein are subject to change without notice.• Specifications and battery cartridge may differ from country to country.• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-est combinations, according to EPTA-Procedure 01/2014, are shown in the table.Applicable battery cartridge and chargerBattery cartridge BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860BCharger DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /DC18SH• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridgesand chargers may cause injury and/or fire.Intended useThe tool is intended for fastening bolts and nuts.NoiseThe typical A-weighted noise level determined accord-ing to EN62841-2-2:Sound pressure level (LpA ) : 74 dB(A)Uncertainty (K) : 3 dB(A)The noise level under working may exceed 80 dB (A).NOTE: The declared noise emission value(s) has beenmeasured in accordance with a standard test methodand may be used for comparing one tool with another.NOTE: The declared noise emission value(s) mayalso be used in a preliminary assessment of exposure.WARNING: Wear ear protection.WARNING: The noise emission during actualuse of the power tool can differ from the declaredvalue(s) depending on the ways in which the tool isused especially what kind of workpiece is processed.WARNING: Be sure to identify safety measuresto protect the operator that are based on an estima-tion of exposure in the actual conditions of use (tak-ing account of all parts of the operating cycle suchas the times when the tool is switched off and whenit is running idle in addition to the trigger time).VibrationThe vibration total value (tri-axial vector sum) deter-mined according to EN62841-2-2:Work mode: fasteningVibration emission (a h ) : 2.5 m/s 2Uncertainty (K) : 1.5 m/s2NOTE: The declared vibration total value(s) has beenmeasured in accordance with a standard test methodand may be used for comparing one tool with another.NOTE: The declared vibration total value(s) may alsobe used in a preliminary assessment of exposure.WARNING: The vibration emission during actualuse of the power tool can differ from the declared val-ue(s) depending on the ways in which the tool is usedespecially what kind of workpiece is processed.WARNING: Be sure to identify safety measuresto protect the operator that are based on an estima-tion of exposure in the actual conditions of use (tak-ing account of all parts of the operating cycle suchas the times when the tool is switched off and whenit is running idle in addition to the trigger time).EC Declaration of ConformityFor European countries onlyThe EC declaration of conformity is included as Annex Ato this instruction manual.