Makita EA3201 SERIES Original Instruction Manual

Makita EA3201 SERIES Original Instruction Manual Manual pdf 24 page image

24Use an oil with adhesive additive for lubricating the chain andguide bar. The adhesive additive prevents the oil from beingflung off the chain too quickly.We recommend the use of chain oil which is bio‑degradable inorder to protect the environment. The use of bio‑degradable oilmay even be required by local regulations.The chain oil BIOTOP sold by MAKITA is made of specialvegetable oils and is 100% bio‑degradable. BIOTOP has beengranted the “blue angel” (Blauer Umweltschutz‑Engel) forbeing particularly environment‑friendly (RAL UZ 48).BIOTOP chain oil is available in the following sizes:1 l order number 980 008 6105 l order number 980 008 611Bio‑degradable oil is stable only for a limited period of time. Itshould be used within 2 years from the date of manufacture(printed on the container).Important note on bio-degradable chain oilsIf you are not planning to use the saw again for an extendedperiod of time, empty the oil tank and put in a small amountof regular engine oil (SAE 30), and then run the saw fora time. This is necessary to flush out all remaining bio‑degradable oil from the oil tank, oil‑feed system, chain andguide bar, as many such oils tend to leave sticky residuesover time, which can cause damage to the oil pump or otherparts.The next time you use the saw, fill the tank with BIOTOPchain oil again. In case of damage caused by using wasteoil or inappropriate chain oil the product guarantee will benull and void.Your salesman will inform you about the use of chain oil.waste oilNEVER USE WASTE OILWaste oil is very dangerous for the environment.Waste oil contains high amounts of carcinogenic substances.Residues in waste oil result in a high degree of wear and tearat the oil pump and the sawing device.In case of damage caused by using waste oil or inappropriatechain oil the product guarantee will be null and void.Your salesman will inform you about the use of chain oil.AVOID SKIN AND EYE CONTACTMineral oil products degrease your skin. If your skin comes incontact with these substances repeatedly and for an extendedperiod of time, it will desiccate. Various skin deseases mayresult. In addition, allergic reactions are known to occur.Eyes can be irritated by contact with oil. If oil comes into youreyes, immediately wash them with clear water.If your eyes are still irritated, see a doctor immediately!6-7. Chain oilFOLLOW THE SAFETY PRECAUTIONS!Be careful and cautious when handling fuels.The engine must be switched off!Thoroughly clean the area around the caps, to prevent dirtfrom getting into the fuel or oil tank.(Fig. 51)Unscrew the tank cap (use the universal wrench if necessary,see illustration) and fill tank with fuel mixture or saw chain oilup to the bottom edge of the filling neck. Be careful not to spillfuel or chain oil!Chain oilFuel/oil mixtureScrew on the tank cap by hand all the way.Clean the tank cap and the area around the tank afterrefuelling.Lubricating the chainDuring operation there must always be sufficient chain oil inthe chain‑oil tank to provide good chain lubrication. At mediumoil feed rate, the oil tank holds enough for one fuel tank’s worthof operation. During this procedure check whether there isenough the chain oil in the tank and refill if necessary. Do thisonly with the engine turned off!Screw on the tank cap by hand all the way.CAUTION:Be careful not to let the tank cap touch with the muffler. Heatedmuffler may deform it.6-8. Filling fuel and chain oil