Makita EA5600F Operator's And Safety Manual

Also see for EA5600F: Operator's and safety manual Operator's and safety manual Instruction manual

2142AB1Checking the chain tensionThe tension of the chain is correct if the chain rests againstthe bottom side of the guide bar and can still be easily turnedby hand.While doing so the chain brake must be released.Check the chain tension frequently - new chains tend to getlonger during use!When checking the chain tension the engine must be switchedoff.NOTE:It is recommended to use 2-3 chains alternatively.In order to guarantee uniform wear of the guide bar the barshould be turned over whenever replacing the chain.Retightening the saw chainLoosen the nuts (2) about one turn with the universal wrench.Raise the tip of the guide bar a little and turn the chain tensioningscrew (4) to the right (clockwise) until the saw chain is again upagainst the bottom edge of the guide bar (see circle).While keeping the tip of the guide bar raised, tighten the nuts(2) again with the universal wrench.Engaging the chain brake (braking)If the kickback is strong enough the sudden acceleration of theguide bar combined with the inertia of the hand guard (1) willautomatically actuate the chain brake.To engage the chain brake manually, simply push the handguard (1) forward (towards the tip of the saw) with your lefthand (arrow A).Releasing the chain brakePull the hand guard (1) towards you (arrow B) until you feel itcatch. The brake is now released.Chain brakeThe EA5600F comes with an inertia chain brake as standardequipment. If kickback occurs due to contact of the guide-bartip with wood (see SAFETY PRECAUTIONS, page 8, 12), thechain brake will stop the chain through inertia if the kickbackis sufficiently strong.The chain will stop within a fraction of a second.The chain brake is installed to block the saw chain beforestarting it and to stop it immediately in case of an emer-gency.IMPORTANT: NEVER run the saw with the chain brake acti-vated (except for testing, see “Testing chain brake”)! Doing socan very quickly cause extensive engine damage!ALWAYS release the chain brakebefore starting the work!