Makita EB7650TH Original Instruction Manual

Also see for EB7650TH: Original instruction manual Original instruction manual Technical information Original instruction manual Instruction manual

Contents

Makita EB7650TH Original Instruction Manual Manual pdf 10 page image

10BEFORE STARTING THE ENGINE1. Checking and Refilling Engine Oil1) Perform the following procedure, with the engine cooled down.Otherwise skin burn may result.Inspection: Put the blower on a flat surface and remove the oilcap.Check the oil gauge (1). Make sure that the oil level iswithin the upper (2) and lower (3) limit marks. If the oilis not up to the 100 ml level (4), fill up with new oil.Filling oil: Put the blower on a flat surface and remove the oilcap.Fill the oil up to the upper limit of the oil level gauge.2) On average, engine oil needs to be added after every 20 hours ofoperation (every 10 – 15 refuellings).3) Change the oil whenever it becomes dirty or significantly changescolor. (Refer to “Replacement of engine oil” for the oil changeprocedure and frequency.)●●Recommended oil: Makita genuine oil or SAE10W-30 oil of API type SF grade or better (4 stroke motor oil for automobiles)Oil capacity: Approximately 0.22 L (220 ml)NOTE:If the blower is not stored in an upright position, the oil may flow from the level gauge into the engine and give a false reading when checking theoil level. This may result in inadvertently overfilling whenever adding engine oil. Always store the blower in an upright position.If the engine oil is exceeded, the oil may spill from the breather of the air cleaner and make surrounding parts dirty, or white smoke may appeardue to burning excessive oil.Replacement of Oil “Oil cap”Remove dust or dirt near the oil refill port, and detach the oil cap.Keep the detached oil cap free of sand or dust. Otherwise, any sand or dust adhering to the oil cap may cause irregular oil circulation or wear onthe engine parts, which will result in troubles.After refilling oilWipe with a rag any spilled oil.●●●●●(1)(2)(4)(3)