Makita EBH340R Instruction Manual

Also see for EBH340R: Instruction manual

Contents

Makita EBH340R Instruction Manual Manual pdf 9 page image

9CAUTION : Before performing any work on the brushcutter, always switch off the motor and pull thespark plug connectors off the spark plug.Beware of hot engine pars and sharp bladeedges.Always wear protective gloves!CAUTION : Start the brush cutter only after having as-sembled it completely.1. Joining flexible pipe with engine and pipe case holderInsert on end of a flexible pipe (1) into a clutch housing (2) onan engine until it locks with a slight “click” noise.Insert the other end of the flexible pipe into a pipe case (3)holder of a brush cutter until it locks.Each end of the flexible pipe is interchangeable.Make sure that a squsre end of a flexible shaft fits into the jointof a drive shaft.CAUTION : If you have difficulty to insert the flexible pipeproperly, the square end of the flexible shaftmay not fit the drive shaft joint. Do not force topush to avoid damage on the flexible shaft end.Repeat the same procedure again until flexibleshaft and pipe fit properly.2. Mounting of control cable– Remove the air cleaner cover.– Place the control cable (4) in the adjusting bolt (5), and shift theswivel (6) so that the cable will be put in the swivel groove. Atthis time, the round-hole side of the swivel will be orientedtoward the inner wire end-metal fitting.– Release the swivel, and confirm that the inner wire-end metalfitting will be placed in the hole.– Mount the air cleaner cover.ASSEMBLY OF ENGINE AND DRIVE SHAFTRound-holeEnd fittingControl cableSwivelInsert