Makita EBH341R Original Instruction Manual

Makita EBH341R Original Instruction Manual Manual pdf 10 page image

10CAUTION: Before performing any work on the brush cutter, always switchoff the motor and pull the spark plug connectors off the sparkplug. Beware of hot engine pars and sharp blade edges.Always wear protective gloves!CAUTION: Start the brush cutter only after having assembled itcompletely.1. Joining flexible pipe with engine and pipe case holderInsert on end of a flexible pipe (1) into a clutch housing (2) on an engine untilit locks with a slight “click” noise.Insert the other end of the flexible pipe into a pipe case (3) holder of a brushcutter until it locks.Each end of the flexible pipe is interchangeable.Make sure that a squsre end of a flexible shaft fits into the joint of a driveshaft.CAUTION: If you have difficulty to insert the flexible pipe properly, thesquare end of the flexible shaft may not fit the drive shaft joint.Do not force to push to avoid damage on the flexible shaft end.Repeat the same procedure again until flexible shaft and pipefit properly.ASSEMBLY OF ENGINE AND DRIVE SHAFT2. Mounting of control cableRemove the air cleaner cover.–Place the control cable (4) in the adjusting bolt (5), and shift the swivel (6) so–that the cable will be put in the swivel groove. At this time, the round-hole sideof the swivel will be oriented toward the inner wire endmetal fitting.Release the swivel, and confirm that the inner wireend metal fitting will be–placed in the hole.Mount the air cleaner cover.–SwivelEnd fittingRound-holeControl cable Insert