Makita EK7650H Owner's And Safety Manual

Also see for EK7650H: Instruction manual Original instruction manual Instruction manual Original instruction manual Instruction manual

Contents

22Changing the cutting attachment position(central/side)Mounting direction of hoodThe Power Cutter’s cutting attachment is mounted in the•direction shown in Fig. A. If desired, use the following procedureto mount it in the direction shown in Fig. B.Mounting in direction B(1) Loosen tightening nut, and turn tension adjustment screw tothe left until the end of the screw is visible. (Fig. 1)(2) Remove tightening nuts and remove belt cover. (Fig. 1)(3) Rotate the hood to the broken line position. Remove V-beltand then remove cutting attachment from the Power Cutter.Reposition the grip. (Fig. 2)(4) Pick up the lock shaft with a slotted screwdriver or a plier.(Fig. 3)(5) Rotate the arm until it contacts the grip and return the lockshaft to the original position by hand. (Fig. 4)Reposition the grip. (Fig. 5)(6) Turn over the removed cutting attachment, pass bolt throughhole, and remount in direction B.Remount the V-belt to the pulley. (Fig. 6)(7) Mount belt cover. (Fig. 7)Turn the tension adjustment screw to adjust the tension of theV-belt. Once tension adjustment is finished, firmly tighten thetightening nut.Hex. nutsHoodV-beltLock shaftV-beltPulleyBoltsBelt coverBelt coverHex. nutHolesTension adjustment screwMounting directionBelt coverEnd of screwA BFig. 1Fig. 2Fig. 3Fig. 5 Fig. 6 Fig. 7PlierRelocateBoltsGripArmGripFig. 4