Makita EK7650H Technical Information

Also see for EK7650H: Instruction manual Owner's and safety manual Original instruction manual Instruction manual Original instruction manual

[4] DISASSEMBLY/ASSEMBLY[4]-2. Starter assemblyR epairP 6/ 19(1) Loosen three M5x19 - Hexalobular socket head bolts, then removeStarter assembly. (Fig. 10)(2) When Starter rope is not broken;1. Make a slack of Starter rope then hook it on U-shaped notch of Reel.(Fig. 11)2. Be sure to loosen the spiral spring force by turn Reel clockwise to spinStarter rope around Reel before the step (3). (Fig. 11)(3) Loosen M6x20 Set screw with Phillips screwdriver No. 3. (Fig. 11)(4) When Reel is removed from Starter case, insert a index finger carefully tothe reverse side of Reel and then remove Reel from Starter case withSpiral spring attached. (Fig. 12.)Fig. 10Fig. 13Fig. 11DISASSEMBLINGASSEMBLINGFig. 12(1) If Spiral spring pops out of Reel, put it back in place by settingthe outer end of Spiral spring in place in Reel first, then by windingSpiral spring counterclockwise towards the center of Reel. (Fig. 13)(2) Apply a little amount of Makita grease N No.2 to the whole surfaceof Spiral spring.(3) Put Starter rope through Starter case complete.After passing the one end through Starter knob and Rope stopper,tie the end as drawn in Fig. 14. Then cover the top of Starter knobwith Cap.After passing the other end from the hole of Starter case to Reel,tie the end in Reel.(4) Wind Starter rope around Reel for the 2/3 length (When the wholelength is 1m, wind 66cm.)(5) While setting the inner end of Spiral spring into the center slot ofStarter case, assemble Reel to Starter case properly.(6) Tighten M6x20 Set screw with Phillips screwdriver No. 3. (Fig. 11)(7) Make a slack of Starter rope then hook it on U-shaped notch ofReel. (Fig. 11) Turn Reel counterclockwise to spin Starter ropearound Reel.Important: Make sure that the proper spring force is effective to Starterassembly by turning Starter knob by hand and it can bereturned back to the original position. (Fig. 15)Even if Starter rope is pulled to the full, there is room torotate Reel because of Spiral spring performance.M5x19 - Hexalobularsocket head bolt(3 pcs.)ReelStarter caseStarter assembly (gray portion)Starter ropeReelU-shapednotch of ReelM6x20 Set screw Spiral springSpiral springReelFig. 14Fig. 15Rope stopperCapStarter knobHole of Starter caseHold Spiral springby an index finger.Set the outer end ofSpiral spring here.