Makita EN5550SH Owner's And Safety Manual

Also see for EN5550SH: Catalog Parts Breakdown Manual

Contents

Makita EN5550SH Owner's And Safety Manual Manual pdf 16 page image

16MAINTENANCEBefore performing any maintenance work on the pole hedge cutter (blade-cleaning, etc.), always stop the engine and wait until the engine has cooled down.As an additional safety precaution, also remove the spark plug cap.Do not try to straighten or weld bent or broken cutting blades. Always replace-damaged blades.Stop the engine at regular intervals to check the cutting blades for possible-damage (perform a tapping-resonance test to detect hard-to-see hairline cracks).Always make sure that the teeth of the blades are sharp.Clean the pole hedge trimmer regularly. During cleaning also check all screws,-nuts and bolts are well tightened.To reduce the risk of fire, never service or store the pole hedge trimmer in the-vicinity of open fires.Always wear rugged protective gloves when handling the cutting blades.-Contact your dealer for replacement cutting blades.-Never use gasoline, benzine, thinner, alcohol or the like. Discoloration,-deformation or cracks may result.Sharpening the bladeIf the cutting blades have become blunt and cutting performance is poor, have theblades sharpened by an authorized service agent.Adjusting blade clearanceThe upper/lower blades wear. If you cannot get a clean cut though the blades are sharp enough, adjust the clearance as follows.1. Loosen the nut (1) with a box or open-ended wrench.2. Tighten the truss bolt (2) with a hex wrench lightly till it stops and screw it back between a quarter turn and a half turn.3. Tighten the nut (1), holding the truss bolt (2).4. Apply light oil on the friction surface of the blades.5. Start the engine, operate the throttle on and off for a minute.6. Stop the engine and touch the surface. If they are not too hot to touch, you have made a proper adjustment. If they are too hot to touch, turnthe truss bolt (2) back a little and repeat the step 5 to 6.NOTE: Before making the adjustment, stop the engine and wait for the blades to stop.The blades have a slot around the truss bolt (2). In case you find dust in the end of any of the slots, clean it.1234561 Hexagonal U-nut2 Truss bolt3 Flat washer4 Blade guide5 Upper blade6 Lower blade