Makita ER2650LH Original Instruction Manual

Also see for ER2650LH: Instruction manual Technical information Original instruction manual Instruction manual

Contents

8CAUTION: Before doing any work on the equipment, always stop theengine and pull the spark plug connector off the spark plug.Always wear protective gloves!CAUTION: Start the engine only after having assembled it completely.For machines with loop handleFix the loop handle on the shaft as shown.–Make sure that the spacer on the shaft pipe is located between the grip–assembly and the other grip. Do not remove or shrink the spacer.NOTE: In some countries, the spacer is not provided with the tool. In that case,align the handle to further side of the line which is indicated by thearrow marks.MOUNTING OF HANDLETo meet the applicable safety provisions, only the tool/protectorcombinations as indicated in the table must be used.MOUNTING OF PROTECTORCAUTION: Do not touch the cord cutter on the protector. Touching the cordcutter with bare hands may result in injury.The protector must be installed to maintain the nylon-cutting-cord length andprotect the operator from thrown stones and debris. Install the protector as thefollowing steps.1έ Set the protector so that the rib on the shaft its into the groove on theprotector.2. Tighten two bolts.Cord cutter ProtectorBoltsWARNING: Never use cutting blades.Be sure to use genuine MAKITA nylon cutting head.If the nylon cutting head hits against a stone during operation, stop the–engine and check the nylon cutting head immediately.CAUTION: Do not touch the cord cutter on the protector. Touching the cordcutter with bare hands may result in injury.Mount a nylon cutting head as the following steps.1. Insert the lock key through the hole on the clamp. Rotate them with pushingthe lock key in until they are locked.2. Screw a nylon cutting head onto the shaft by turning it clockwise. Make surethat it is mounted securely.3. Remove the lock key.To remove the nylon cutting head, turn it counterclockwise.MOUNTING OF NYLON CUTTING HEADClampTighten LoosenLock keyCord cutterNylon cuttinghead