Makita ER2650LH Original Instruction Manual

Also see for ER2650LH: Original instruction manual Instruction manual Technical information Instruction manual

Contents

1380 mm100 mmCoverLatchesPressPressSpoolFor right handrotationNotchesEyeletsReplacing the nylon cordWARNING: Make sure that the cover of the nylon cutting head is securedto the housing properly as described below. Failure to properlysecure the cover may cause the nylon cutting head to fly apartresulting in serious personal injury.Press inward on the housing latches and lift upward to remove the cover.Discard any of the remaining nylon cord.Hook the middle of the new nylon cord to the notch located at the center of thespool between the 2 channels provided for the nylon cord. One side of the cordshould be about 80 mm longer than the other side.Wind both ends firmly around the spool in the direction marked on the head forright hand direction indicated by RH.Wind all but about 100 mm of the cords, leaving the ends temporarily hookedthrough a notch on the side of the spool.Mount the spool in the housing so that the grooves and protrusions on the spoolmatch up with those in the housing. Now, unhook the ends of the cord from theirtemporary position and feed the cords through the eyelets to come out of thehousing.Align the protrusion on the underside of the cover with the slots of the eyelets.Then push cover firmly onto the housing to secure it. Make sure the latches fullyspread in the cover.CoverProtrusion(Not shown)Slot ofeyelet