Makita FS2200 Instruction Manual

Also see for FS2200: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita FS2200 Instruction Manual Manual pdf 6 page image

6NOTE:• Use a dry cloth to wipe the dirt off the lens of lamp.Be careful not to scratch the lens of lamp, or itmay lower the illumination.Reversing switch actionFig.7CAUTION:• Always check the direction of rotation before operation.• Use the reversing switch only after the tool comesto a complete stop. Changing the direction ofrotation before the tool stops may damage the tool.This tool has a reversing switch to change the directionof rotation. Move the reversing switch lever tothe position (A side) for clockwise rotation orthe position (B side) for counterclockwise rotation.HookFig.8The hook is convenient for temporarily hanging the tool.ASSEMBLYCAUTION:• Always be sure that the tool is switched off andunplugged before carrying out any work on the tool.Installing or removing the bitFor model FS2200, FS2300To remove the bit, first remove the locator by pulling thelock ring away from the gear housing.Fig.9Grasp the bit with a pair of pliers and pull the bit out ofthe magnetic bit holder. Sometimes, it helps to wigglethe bit with the pliers as you pull.To install the bit, push it firmly into the magnetic bitholder. Then install the locator by pushing it firmly backonto the gear housing.Fig.10For model FS2300XTo remove the bit, first pull the locator out of the lockingsleeve. Then grasp the bit with a pair of pliers and pullthe bit out of the magnetic bit holder. Sometimes, ithelps to wiggle the bit with the pliers as you pull.Fig.11To install the bit, push it firmly into the magnetic bitholder. Then install the locator by pushing it firmly backonto the locking sleeve.Fig.12Use of locator holderFig.13The locator can be temporarily held on the locatorholder during replacing bit or using without locator. Tohold the locator, position the trapezoidal holes of thelocator on the swells of the locator holder and push it in.OPERATIONFig.14Fit the screw on the point of the bit and place the pointof the screw on the surface of the workpiece to befastened. Apply pressure to the tool and start it.Withdraw the tool as soon as the clutch cuts in. Thenrelease the switch trigger.CAUTION:• When fitting the screw onto the point of the bit, becareful not to push in on the screw. If the screw ispushed in, the clutch will engage and the screwwill rotate suddenly. This could damage aworkpiece or cause an injury.• Make sure that the bit is inserted straight in thescrew head, or the screw and/or bit may bedamaged.• Hold the tool only by the handle when performingan operation. Do not touch the metal part.MAINTENANCECAUTION:• Always be sure that the tool is switched off andunplugged before attempting to perform inspectionor maintenance.• Never use gasoline, benzine, thinner, alcohol orthe like. Discoloration, deformation or cracks mayresult.To maintain product SAFETY and RELIABILITY, repairs,carbon brush inspection and replacement, any othermaintenance or adjustment should be performed byMakita Authorized Service Centers, always using Makitareplacement parts.OPTIONAL ACCESSORIESCAUTION:• These accessories or attachments arerecommended for use with your Makita toolspecified in this manual. The use of any otheraccessories or attachments might present a risk ofinjury to persons. Only use accessory orattachment for its stated purpose.If you need any assistance for more details regardingthese accessories, ask your local Makita Service Center.• Phillips Insert bits• Magnetic bit holder• LocatorNOTE:• Some items in the list may be included in the toolpackage as standard accessories. They may differfrom country to country.