44. Keep hands away from rotating parts.5. Do not touch the bit or the workpieceimmediately after operation; they may beextremely hot and could burn your skin.SAVE THESE INSTRUCTIONS.WARNING:MISUSE or failure to follow the safety rules stated inthis instruction manual may cause serious personalinjury. USD201-2SymbolsThe followings show the symbols used for tool.・ volts・ amperes・ hertz・ alternating current・ no load speed・ Class II Construction・ revolutions or reciprocation per minuteFUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function onthe tool.Depth adjustmentFor Model FS2700 only12010117When you wish to drive self drilling screws, etc., adjustthe depth as follows. Turn the locator to adjust the depth.Adjust the locator to create a distance of approximately1 mm (3/64") from the tip of the front cap (which works inconjunction with the locator) to the base of the screwhead. One full turn of the locator equals 1 mm (3/64")change in depth.1mm0101181mm010119Switch action12010121CAUTION:• Before plugging in the tool, always check to seethat the switch trigger actuates properly andreturns to the "OFF" position when released.To start the tool, simply pull the switch trigger. Toolspeed is increased by increasing pressure on the switchtrigger. Release the switch trigger to stop.For continuous operation, pull the switch trigger andthen push in the lock button.To stop the tool from the locked position, pull the switchtrigger fully, then release it.NOTE:• Even with the switch on and motor running, the bitwill not rotate until you fit the point of the bit in thescrew head and apply forward pressure to engagethe clutch.1. Switch trigger2. Lock button1. Locator2. Front cap