7Fig.11To install the bit, push it firmly into the magnetic bitholder. Then install the locator by pushing it firmly backonto the locking sleeve.Fig.12Installing removable cord adapterFor Model FS6300RFig.13Insert the removable cord adapter as far as it goes so thatthe marking on an end of the removable cord adapter onthe side of connecting to power supply cord is aligned to themarking on the other end of the removable cord adapteron the side of connecting to the tool.Turn the removable cord adapter clockwise until it islocked with a lock button.Fig.14And at this time the marking on an end of the removablecord adapter on the side of power supply cord is aligned tothe marking on the other end of the removable cordadapter on the side of connecting to the tool.Fig.15Removing removable cord adapterFig.16Rotate the removable cord adapter counterclockwiseuntil it stops while pressing the lower part of the lockbutton.Then pull the removable cord adapter in that position.Fig.17Use of locator holderFig.18The locator can be temporarily held on the locatorholder during replacing bit or using without locator. Tohold the locator, position the trapezoidal holes of thelocator on the swells of the locator holder and push it in.OPERATIONFig.19Fit the screw on the point of the bit and place the pointof the screw on the surface of the workpiece to befastened. Apply pressure to the tool and start it.Withdraw the tool as soon as the clutch cuts in. Thenrelease the switch trigger.CAUTION:• When fitting the screw onto the point of the bit, becareful not to push in on the screw. If the screw ispushed in, the clutch will engage and the screwwill rotate suddenly. This could damage aworkpiece or cause an injury.• Make sure that the bit is inserted straight in the screwhead, or the screw and/or bit may be damaged.• Hold the tool only by the handle when performingan operation. Do not touch the metal part.MAINTENANCECAUTION:• Always be sure that the tool is switched off andunplugged before attempting to perform inspectionor maintenance.• Never use gasoline, benzine, thinner, alcohol orthe like. Discoloration, deformation or cracks mayresult.To maintain product SAFETY and RELIABILITY, repairs,carbon brush inspection and replacement, any othermaintenance or adjustment should be performed byMakita Authorized Service Centers, always using Makitareplacement parts.OPTIONAL ACCESSORIESCAUTION:• These accessories or attachments arerecommended for use with your Makita toolspecified in this manual. The use of any otheraccessories or attachments might present a risk ofinjury to persons. Only use accessory orattachment for its stated purpose.If you need any assistance for more details regardingthese accessories, ask your local Makita Service Center.• Phillips Insert bits• Magnetic bit holder• Locator• Plastic carrying caseNOTE:• Some items in the list may be included in the toolpackage as standard accessories. They may differfrom country to country.