Makita GN900 Instruction Manual

Also see for GN900: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita GN900 Instruction Manual Manual pdf 8 page image

8Detach the cap (in case the metering valve is providedwith the cap).009446Push in the front edge.009447Push in the rear edge until it seats.Inserting the fuel cell009448Push up and pull the fuel cover to open.1009449Insert the fuel cell directing the jet nozzle of themetering valve toward the adaptor.009450Insert the jet nozzle into the small hole of the adapterproperly.009451Put the fuel cover over the metering valve and push itdown to latch.Adjusting the nailing depthCAUTION:• Remove the fuel cell, the battery cartridge andnails before adjusting the depth of nailing.1009456With the hex wrench, loosen two screws and move thecontact element.Retighten screws firmly.Indication lampColor of the indication lamp means the followings.Blinking green: Normal statusBlinking red: Need to recharge the battery cartridgeLighting-up-red: Recharge the battery cartridge.Nailing cannot be performed due to no remainingbattery capacity.Blinking orange after blinking green and redalternately: Fault detection is running. Remove andreinsert the battery cartridge to reset. If fault detection isrunning again, it is malfunction condition.1. Screws1. Jet nozzle