Makita HM1317C Instruction Manual

Also see for HM1307C: Instruction manual Instruction manual Instruction manual Instruction manual Instruction mamual

Contents

Makita HM1317C Instruction Manual Manual pdf 7 page image

7CAUTION:• Always assure that the bit is securely retained byattempting to pull the bit out of the tool holder aftercompleting the above procedure.• The bit without a collar cannot be retained by themethod shown in Fig. 7.To remove the bit, follow the installation procedure inreverse.OPERATIONChipping/Scaling/Demolition (Fig. 9)Always use the side grip (auxiliary handle) and firmly holdthe tool by both side grip and switch handle duringoperations. Turn the tool on and apply slight pressure onthe tool so that the tool will not bounce around,uncontrolled. Pressing very hard on the tool will notincrease the efficiency.MAINTENANCECAUTION:• Always be sure that the tool is switched off andunplugged before attempting to perform inspection ormaintenance.LubricationCAUTION:• This servicing should be performed by MakitaAuthorized or Factory Service Centers only.This tool requires no hourly or daily lubrication because ithas a grease-packed lubrication system. However, it isrecommended to periodically replace the grease forlonger tool life.First, switch off and unplug the tool.For model HM1307C, HM1307CB onlyRemove the six screws using a hex wrench and removethe rear cover. (Fig. 10)Pull out the crank cap in the direction of arrow and removeit. (Fig. 11)Then replenish with fresh grease (60g). Use only Makitagenuine hammer grease (optional accessory). Filling withmore than the specified amount of grease (approx. 60 g; 2oz) can cause faulty hammering action or tool failure. Fillonly with the specified amount of grease.To reassemble the tool, follow the disassemblingprocedure in reverse. (Fig. 12)For model HM1317C, HM1317CB onlyRemove the six screws using a hex wrench and removethe rear cover. (Fig. 10)Pull out the crank cap cover in the direction of arrow andremove it. (Fig. 13)Then replenish with fresh grease (60 g). Use only Makitagenuine hammer grease (optional accessory). Filling withmore than the specified amount of grease (approx. 60 g; 2oz) can cause faulty hammering action or tool failure. Fillonly with the specified amount of grease.To reassemble the tool, follow the disassemblingprocedure in reverse. (Fig. 14)CAUTION:• Be careful not to damage the brush holder unit andcarbon brushes especially when installing the rearcover.• Do not reuse the six bolts but use new ones in thereassembling since these bolts are applied withadhesive.To maintain product SAFETY and RELIABILITY, repairs,any other maintenance or adjustment should beperformed by Makita Authorized Service Centers, alwaysusing Makita replacement parts.OPTIONAL ACCESSORIESCAUTION:• These accessories or attachments are recommendedfor use with your Makita tool specified in this manual.The use of any other accessories or attachments mightpresent a risk of injury to persons. Only use accessoryor attachment for its stated purpose.If you need any assistance for more details regardingthese accessories, ask your local Makita Service Center.• Bull point• Cold chisel• Scaling chisel• Clay spade• Rammer• Hammer grease• Safety goggles• Plastic carrying caseNOTE:• Some items in the list may be included in the toolpackage as standard accessories. They may differ fromcountry to country.

/ 24

Related manuals for Makita HM1307C

Makita HM1317C Instruction Manual

This manual is suitable for:

HM1307C HM1307CB HM1317C HM1317CB

manualsdatabase

Your AI-powered manual search engine